MTD 600 Series Operator's Manual page 8

U-Joint Side Crank Chute Control
1. Position chute assembly over base.
See Figure 2-13.
Figure 2-13
2. Close flange keepers to secure chute
assembly to chute base. Flange keepers
will click into place when properly
secure. See Figure 2-14.
8 S 2 — A
ection SSembly
Figure 2-12
NOTE:
secured to the flange on the chute base.
The lower edge of the chute keeper
should be positioned below the flange
on the chute base after being clicked
into place. If flange keepers will not
easily click into place, use palm of your
hand to apply swift, firm pressure to the
back of each.
& S -U
et p
Figure 2-14
Ensure the lower chute is
Chute Directional Control
Assembly
1. Remove cotter pin from end of
unattached chute directional control
assembly.
2. Insert unattached chute directional
control assembly into eye bolt on left
side of handle assembly. See Figure 2-15.
Figure 2-15
3. Line up holes in the end of unattached
chute directional control assembly
with holes in U-joint attached to lower
chute directional control assembly.
Insert cotter pin (a). See Figure 2-15. If
necessary, bracket securing lower chute
directional control assembly to chute
base can be adjusted. Refer to Chute
Bracket Adjustment in Service section
on page 21.
STOP!
Continue to Set-Up
(page 14).
STOP
(a)