Appendix 6 Using Virtual Memory
The NSA-series Industrial PC is set by default to not use virtual memory. When
physical memory alone is not sufficient, it is necessary to set up a paging file and
use virtual memory. This section will explain how to set up a paging file in the DOM
(Disk on Module flash memory) so that virtual memory can be used.
There is a limit to the number of times that the DOM can be written. Setting a paging file
Note
will shorten the life of the DOM. Create a paging file on the DOM only when the physical
memory capacity is insufficient. Generally, when using the NSA-series Industrial PC, it
is recommended to return the paging file setting to its default setting, so that the paging
file is not used.
Appendix 6-1 Setting and Deleting the Paging File
1. Select Start – Control Panel – Performance and Maintenance – System
Properties, and click on the Advanced Tab. Click the Settings Button in the
Performance Area.
If the Control Panel is set to classic mode, select Start – Control Panel – System
Note
Properties.
Appendix 6 Using Virtual Memory
Appendix 6-1 Setting and Deleting the Paging File
Appendix
Appendix-29