Table of Contents
Advertisement
Go into ACTIVE Mode - Step by Step Description
To go into active mode several steps are needed, please refer to the data sheet SLVSBC4.
1. Install the GUI software on a Windows PC.
2. Connect the EVM with the TIGER board, and the TIGER board to a PC USB connector.
3. Start the GUI software.
4. Power up the EVM by connecting VBATP and VBAT to, for example, a 14-V power supply. Observe
the quiescent current.
5. Drive the WD with T = 74 ms, t
(see SLVSBC4).
6. Set AutoSet DIAG EXIT MASK.
7. After setting the DIAG EXIT MASK, press the IGN button.
SLVU847 – April 2013
Submit Documentation Feedback
= 1%, (standard setting), values can be changed
(high)
WD
Tt =
Figure 5-1. WD Timing
Figure 5-2. Start-Up Screen
Copyright © 2013, Texas Instruments Incorporated
t = 1%
74msT
Go into ACTIVE Mode - Step by Step Description
Chapter 5
SLVU847 – April 2013
11
Advertisement
Table of Contents
