Ignition And Start Up (N62X, N62Xx, N82X, And N82Xx Models); Do A Test Of The Gas Safety Valve; Shut Down-All Models - Norcold N621 Installation Manual

If an energy source is available to the refrigerator, but is not
operating correctly:
- A fault code shows in the center display.
- The refrigerator controls try to change to a less efficient
energy source.
- If a less efficient energy source is not available:
- An audible alarm starts.
- A fault code shows in the center display.
- Refer to the "Fault Codes" section of this manual.
Set the controls to manual mode operation:
- Push the ON / OFF button to turn the refrigerator on.
- Push and hold the MODE button until the letters " AC" show
in the center display and then release.
- After ten seconds, the "AC" goes off and only a green
power ON light remains.
- Push and hold the MODE button until the letters "LP" show
in the center display and then release.
- After ten seconds, the "LP" goes off and only a green
power ON light remain
Ignition and start up:
(N62X, N62XX, N82X, and N82XXX models)
(See Art01019)
If
NOTE: the gas does not ignite in 30 seconds, the gas safety
valve of the refrigerator automatically closes and the
controls either select a different energy source or "F"
appears in the center display. This means that the gas
did not ignite.
If the gas does not ignite after several attempts, refer to the
"Fault Codes" section of this manual.
Automatic Mode Operation:
1. Push the ON/OFF button [1] to start the refrigerator.
2. Push the TEMP SET button [2] as needed to set the thermo-
stat at "4-6" temperature setting.
- If the AUTO bar [3] and AC bar [4] appear in the center
display [5], it means that:
- 120 volt AC power is available to the refrigerator.
- The refrigerator is operating on AC electric power.
- If the AUTO bar and the LP GAS bar [6] appear in the center
display, it means that:
Installation Manual 12
- 120 volt AC power is not available to the refrigerator.
- The refrigerator is operating on propane gas.
Manual Mode Operation:
1. Push the ON/OFF button [1] to start the refrigerator.
2. Push the MODE button [8] until the AUTO bar goes off and
only the LP GAS bar remains.
3. Push the TEMP SET button [2] as needed, to set the thermo-
stat at "4-6" temperature setting.
4. The LP GAS bar remains until you select a different operating
mode or shut down the refrigerator.

Do a test of the gas safety valve:

1. Start up the refrigerator in the manual mode operation.
2. Open the lower intake vent.
3. Remove one wire from the solenoid of the gas safety valve at
the rear of the refrigerator.
4. Within 30 seconds, the flame should extinguish. This
means that the gas safety valve is operating correctly.
5. Put the wire back on the solenoid of the gas safety valve.
6. Close the lower intake vent.
Shut down - all models:
To shut down the refrigerator, push and hold the ON/OFF button
for two seconds.