Installing Rear Fence Guide Bar - Sears 113.298721, 113.298761 Owner's Manual

6. Turn front bar end for end and insert bolts through
holes in middle and on right sides of front of saw table
as illustrated. Install Iockwashers and nuts. DON'T
SCREW NUTS ON ALL THE WAY, just get them
started on the screws.
7. Insert 1-1/4 long screwthough slot in bar that matches
hole in bracket. Install spacer, Iockwasher and nut.
DON'T SCREW NUTS ON ALL THE WAY, just get
them started on the screws.
iNSTALLING
REAR FENCE GUIDE BAR
1. From among the loose parts find the following:
1 Bracket
*2 Hex Head Screws 5/16-18 x 1
*2 Hex Head Screws 5/16-18 x 3/4
*4 Flat Washers 5/8 x 1116
*4 External Lockwashers 5/16
*4 Hex Nuts, 5/16-18
1 Rear Fence Guide Bar
Items marked with an asterik (*) are shown actual size.
5/16-18 x 1 IN
HEX HD. SCREW
5/16 IN
EXTERNAL 5/16-18
LOCKWASHER HEX NUT
5/16-18 x 3/4
HEx HEAD
SCREW
REAR FENCE GUIDE BAR
FLAT WASHER
BRACKET
2. Put the bracket against the right rear edge of the right
extension sothe bracket is lined up with the FOURTH
hole near the rear of the extension (see illustration).
3. Insert one of the 3/4 inch long screws through a flat
washer, through the bracket, and through the FOU RTH
hole inthe extension. Install a Iockwashe r and nut on
the screw. Tighten the nut only slightly.
\
HEX NUT
EXTERNAL
LOCKWASH ER
REAR OF
EXTENSION
4TH HOLE
IKET
WASHER
5/16-18 x 3/4
HEX HEAD
SCREW
4. Lay rear fence guide bar on the right rear side of the
saw table as illustrated (as viewed from rear of the
saw). Insert a 3/4 inch long screw through a flat
washer and through the FIRST slot of the rear fence
guide bar. Insert a I inch long screw through a flat
washer and through the FIFTH slot. Insert a I inch
long screw through a flat washer and through the
SEVENTH slot.
5. Turn the fence guide bar end for end and inserttwo of
the 1 inch long screwsthrough thetwo holes inthe left
rear edge of the table. Insert the other 3/4 inch long
screw through the bracket. Instal] a tockwasher and
nut on bolts. DO NOT SCREW NUTS ON ALL THE
WAY. just get them started on the screws.
7TH SLOT 5TH SLOT
HEX HEAD
SCREW
5/16-18 x 1 IN
BACK OF SAW
1ST SLOT
I
HEX HEAD
SCREW
5/16-18 x 3/4 IN,
15