Mounting Switch - Sears 113.298721, 113.298761 Owner's Manual

2. Insert four (4) 5/16-18 x 1-1/4 in. long screws through
hole in each Extension.
3. Position extension against table so screws extend
through hole in fable.
4. Install flat washers, Iockwashers, and nuts on the
screws... DO NOT TIGHTEN.
SAW TABLE
1 (REF)
2 \
3
4
5. Line up the rear edge of extension with the rear edge
of the table and top surface of the extension with the
top of the table at the spots marked"X" in the drawing.
Use a combination square to line-up these edges.
SLIGHTLY TIGHTEN nuts with a 9/16" wrench.
CHECK WITH SQUARE
AT 2 PLACES
MARKED WITH "X"
6. If adjustment is necessary you should tap the exten-
sion into position using a hammer and a block of
wood. Make sure the rear edge of extension is still
lined up with the rear edge of the table. Then firmly
tighten nuts.
7. Repeat steps 2 thru 6 to install the other extension.
MOUNTING SWITCH
1. From among loose parts find the following:
*2 Hex Head Screw 5/16-18 x 3/4
*2 Flatwashers, 21/64 x 5/8 x 1/16
*2 External Lockwashers, 5/16
*2 Hex Nuts, 5/16-18
Items marked with an asterik (*) are shown actual size.
/
/
5/16-18 x 3/4
HEX HEAD SCREW 2t/64 tN WASHER
13
5/16 IN 5/16 IN EXTERNAL
HEX NUT LOCK WASHER