Installing Table Supports - Sears Craftsman 113.23161 Owner's Manual

C._,RR[&OE CO..'ER _k H )
CARRIAGE
LOCK SHOE
h
i.
Install the carriage stop screw and Iockwasher.
Install the carriage lock shoe and carriage lock knob
and tighten the lock knob hand tight. This prevents
the carriage from moving on the radial arm.
CARRIAGE
LOCK KNOB
Remove two power cord clamps from right-hand
side of radial arm, by removing one screw from each
clamp, place the power cord in position and
re-install the cord clamps to secure the power cord
to the arm.
PO'¢.'E _ CORD CLIPS .__
I__
k. Install the front trim panel at end of radial arm with
two screws.
m. Loosen the carriage lock knob and move the carriage
back and forth on the radial arm. Movement should
be "firm" but should not bind at any point along
the arm.
__ RADIAL ARM
___ SCREW
4. Installing Table Supports.
NOTE: R_ght- and left-hand table supports may be
identified by the three "keyholes" in the table
attaching surface of each support. These keyholes
are for attaching the table clamps and are located at
the rear of the saw. Also, the angle of each support
turns outward, away from the saw base.
a Place one 5/16-inch, split Iockwasher and one
11/32-inch plain washer on each of the four 5/16-18
x 3/4-inch hex-head screws, all from the loose parts
pack.
b Attach each table support to the saw base with two
screws, Iockwashers and plain washers.
c Position each support on the base so each screw _s
approximately centered in the slotted hole in the
support.
d Tighten the screws just enough to hold the table
supports in position, but loose enough for the
supports to slip against the base channel when
tapped with a rubber mallet.
t,-_ HOLrS,_r_
[L,_IN ',', z,,SH_.R "_
t I I 32 lINCH) \
f
_C LE',',
_lJ _ TABLE SUPPC, RT
LC, C_" ,',A_HE< K,5 16 INCH)
it" J
;HE,_-HD,5 16-12 _ _z/_' INCH}
/