Section 3-3-4: Heat Shields 5''/8 - Montigo DelRay DRL7213NI Installation & Maintenance Manual

Section 3-3-4: Heat Shields 5''/8''
Installing a Wall Mounted RHS101 Heat shield
Use the RHS101 where any of the dimensions are within the parameters
shown, figure 15.d To install the RHS101, Slide the Inner Section over the
vent pipe that will connect to the fireplace. Then fasten the vent pipe to
the back of the fireplace with a minimum of three sheet metal screws.
From the outside slide the RHS101 outer section on see Figure 15.d
To complete the installation fasten the heat shield outer section &
termination frame to the structure Figure 15.e
RHS101 Heat Shield Outer Section
Termination
Figure 15.c RHS101 Installation. (Install by sliding Outer Section over vent pipe where it passes
through the combustible construction.
RHS101 Heat Shield Outer Section
Termination
Figure 15.d Heat Shield. After sliding the outer section in place.
3/8'' min.
3/8'' min.
Figure 15.e RHS101 Installation
32
Drywall / sheetrock
RHS101 Heat Shield, inner Section
Vent pipe, from fireplace
Combustible framing
Drywall / sheetrock
RHS101 Heat Shield, inner Section
Vent pipe, from fireplace
3/8'' min. Both sides Typical
Inner shield 9 3/8''
Outer shield 10 1/4''
Combustible Framing
491/2'' Min.
Figure 15.b RHS101 Installation. (Minimum requirements).
Installation
DRL
72
RHS101
Heat Shield
PTO Termination
XG0226 - 042220