Ignition And Start Up; Set The Controls To Automatic Mode Operation - Norcold 1210 Installation Manual

Rv refrigerator
Hide thumbs Also See for 1210:
Table of Contents

Advertisement

Available languages

Available languages

Ignition and Start Up

Before ignition or start up of the refrigerator:
- Make sure the air flow in the lower intake vent, through the refrigerator coils and condenser, and out the upper exhaust vent is not
blocked or decreased.
- Make sure there are no combustible materials in or around the refrigerator.
NOTE: If the gas does not ignite in 30 seconds, the gas safety valve of the refrigerator automatically closes. The controls either select
a different energy source or "no" "FL" appears in the center display and you will hear an alarm sound. This means that the gas
did not ignite.
If the gas does not ignite after several attempts, refer to the "Fault Codes" section of this manual.

Set the controls to automatic mode operation:

- Push the ON / OFF button [34] to turn the refrigerator on (See Art01333).
- Push and hold the MODE button [31]] until the
letters "AU" show in the center display and then
release.
- If 120 volts AC is available to the refrigerator:
- The letters "AU" and then "AC" show in the
center display.
- After ten seconds, the "AU" and then "AC"
go off and only a green power ON light
remains.
- This means that the refrigerator is operating on AC electric.
- If 120 volts AC is not available to the refrigerator:
- The letters "AU" and then "AC" show in the center display.
- After five seconds, the "AU" and then "LP" show in the center display.
- After ten seconds, the "AU" and the "LP" go off and only a green power ON light remains.
- This means that the refrigerator is operating on propane gas.
- If neither 120 volts AC nor propane gas is available to the refrigerator:
- The fault codes "no" "AC" and then "no" "FL" show in the center display and an audible alarm sounds.
If an energy source is available to the refrigerator, but is not operating correctly:
- A fault code shows in the center display.
- The refrigerator controls try to change to a less efficient energy source.
Installation Manual 20
32
33
on
SET TEMP
1 COLD-9 COLDEST
31
30
MODE
ON / OFF
Art01333

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents