Table of Contents
Advertisement
Installation and Owner's Instructions
This refrigerator is equipped with an optional water dispenser. The Installation Manual and the Owner's
Manual do not include instructions about this option. Please use these instructions for the Installation and
the Operation of the water dispenser. Keep these instructions with the refrigerator Installation Manual
and Owner's Manual for future use.
NORCOLD, Inc.
P.O. Box 4248
Sidney, OH 45365-4248
Water Dispenser
English
French
Norcold Customer Support Dept.
Telephone: 800-543-1219
Fax: 937-497-3183
Web Site: www.norcold.com
Part No. 629527A (5-06)
Advertisement
Table of Contents
Related Manuals for Norcold 1210
Summary of Contents for Norcold 1210
- Page 1 Installation and Owner’s Instructions This refrigerator is equipped with an optional water dispenser. The Installation Manual and the Owner’s Manual do not include instructions about this option. Please use these instructions for the Installation and the Operation of the water dispenser. Keep these instructions with the refrigerator Installation Manual and Owner’s Manual for future use.
-
Page 2: Table Of Contents
Owner’s Instructions Water Dispenser The water dispenser is assembled to the refrigerators at the factory as optional equipment. If the refrigerator does not have a factory installed water dispenser, one cannot be added to the refrigerator at a later time. -
Page 3: Water Dispenser Shut Off
- The cooling time will vary with the supply water temperature. - A complete refill of the built-in reservoir will take longer 2. Make sure that the air inside the refrigerator can freely circulate around the water reservoir which is located at the rear of the fresh food compartment. -
Page 4: Water Dispenser Cleaning And Disinfecting
- Wash the reservoir, the cover, and the area around the reservoir with a mild cleaner or a solution of liquid dish detergent and warm water. - If you need to clean behind the reservoir, remove the two screws [3] that attach the reservoir to the refrigerator cabinet. - Gently clean behind the reservoir. -
Page 5: Water Dispenser Storage
0° F. or lower. Damage to the water solenoid valves and the water supply line can occur. 1. Close the vehicle water supply valve to the refrigerator. 2. Remove the water supply line [1] from the water solenoid valve [2]. -
Page 6: Troubleshooting
Troubleshooting . f f o l f t t u g i l g i l . f f Owner’s Manual 6 y l t n i l . y l t l i f n i l y l t . -
Page 7: Installation Instructions
NOTE: The doors are made to accept decorative panels. The decorative panels must be 3/16 inch or less in thickness. Install the decorative door panels in the refrigerator doors before installing the refrigerator in the vehicle. 1. Make two upper door panels that are 16 13/64 inches wide x 18 3/8 inches... -
Page 8: Connect The Water Dispenser
The refrigerator installer must connect a cold water supply line to the solenoid valve at the rear of the refrigerator. The following are necessary to connect the water dispenser. - Page 9 - For plastic tubing with .040 in. wall thickness, also use the brass insert [3]. - Flush the water supply line until the water is clear. - Put the water supply line into the compression fitting of the solenoid valves. - Tighten the compression nut by hand (hard finger tight).
- Page 10 Owner’s Manual 10...