Adjusting X And Y Sensors - Bernina Deco 330 Manual

Deco 330
5
6
2

Adjusting X and Y Sensors

4
7
1
3
To adjust X and Y sensors:
1 Turn the power switch "ON" (The carriage is
automatically set at starting position.)
2 Turn the power switch "OFF" and then remove the
base unit.
3 Loosen Screw A
plate 3 to adjust the carriage position.
Turn the power switch "ON" again to check if the
Distance (Y) 2 is adjusted to 2.5 mm.
Tighten Screw (A) 1 .
4 Loosen screw B 4 and move the X-shield plate
7
to adjust the carriage position (X-1) 5 and
(X-2) 6 .
Turn the power switch "ON" again to check if the
distance (X-1) 5 is adjusted to 69.5 mm and
(X-2) 6 is adjusted to 2.5 mm.
5 Tighten Screw 4 .
6. Attach the base.
1 Screw (A)
2 Y (2.5 mm)
Y Sensor fixing plate
3
4 Screw (B)
5
X-1 (69.5 mm)
6
X-2 (2.5 mm) between the edge of carriage
and Base
7 X shield plate
26
1
and move the Y-Sensor fixing