Bandwidth Control - TP-Link TL-WR840N User Manual

Chapter 5
• Destination Network
to which the static route is assigned.
• Subnet Mask - The Subnet Mask determines which portion of an IP address is the
network portion, and which portion is the host portion.
• Gateway - This is the IP address of the gateway device that allows for contact between
the Router and the network or host.
• Interface - This interface tells you whether the Destination IP Address is on the LAN &
WLAN (internal wired and wireless networks), or the WAN (Internet).
Click Refresh to refresh the data displayed.
5 12

Bandwidth Control

1. Visit http://tplinkwifi.net, and log in with the username and password you set for the
router.
2. Go to Bandwidth Control.
3. Tick the Enable Bandwidth Control
and Ingress Bandwidth, and then click Save. The
upload/download speed through the WAN port. The value should be less than
100,000Kbps.
4. Click Add New, fill in the blanks and click Save.
- The Destination Network is the address of the network or host
checkbox, and configure the
Configure the Router in WISP Mode
Egress Bandwidth
Egress/Ingress Bandwidth is the
107