Gas Burner Controls; Control Box; Operation - EarthStone 60-PAGW Installation, Operation And Maintenance Instructions

EARTHSTONE OVENS PRE-ASSEMBLED GAS OVEN INSTALLATION INSTRUCTIONS – ETL LISTED

CONTROL BOX

1
ON/OFF—MAIN SWITCH TO TURN BURNER ON AND OFF
2
HI/OFF---BURNER WILL REMAIN ON HIGH FLAME UNTIL DESIRED TEMPERATURE IS REACHED. ONCE
DESIRED TEMPERATURE IS REACHED BURNER WILL SHUT OFF. WHEN TEMPERATURE FALLS BELOW DESIRED
TEMPERATURE HI FLAME WILL COME BACK ON.
3
HI/LO--- BURNER WILL REMAIN ON HIGH FLAME UNTIL DESIRED TEMPERATURE IS REACHED. ONCE
DESIRED TEMPERATURE IS REACHED BURNER WILL GO TO LOW FLAME. WHEN TEMPERATURE FALLS BELOW
DESIRED TEMPERATURE HI FLAME WILL COME BACK ON.
TEMPERATURE READOUT CONTROLS
4
BLACK DIAL KNOB—ROTATE CLOCKWISE TO RAISE OR COUNTER-CLOCKWISE TO LOWER SET
TEMPERATURE.
5
RED BUTTON—USED SIMULTANEOUSLY WITH BLACK DIAL KNOB TO SET TEMPERATURE. PUSH AND
HOLD, SET TEMPERATURE IS DISPLAYED. WHEN RELEASED ACTUAL TEMPERATURE IS DISPLAYED.
FIRING OVEN (NOTE: DO NOT CLOSE DOOR WHILE OVEN IS BEING FIRED)
MAKE SURE GAS CONTROL VALVE IS IN THE ON POSITION.
WHILE PRESSING RED BUTTON, TURN BLACK KNOB TO DESIRED TEMPERATURE. THIS SHOULD BE
ABOUT 650 F TO 750 F.
MOVE SWITCH TO HI/LOW POSITION.
TURN MAIN POWER SWITCH TO ON. A SPARK IS GENERATED WHICH WILL IGNITE THE GAS AT THE
MAIN BURNER INSIDE THE OVEN.
DAILY THERMAL CLEANING PROCEDURES:
INCREASE OVEN TEMPERATURE TO 850 DEGREES
•

GAS BURNER CONTROLS

SEE PAGE LABELED SWITCH DIAGRAM LAYOUT

OPERATION

8