Table of Contents
Advertisement
TROUBLESHOOTING AND MAINTENANCE
Lamp indicator
Blinks
Error
indicator
Steadily
lit
MEMORY FULL, PRESS START TO
RESUME.
NO 2-SIDED COPY FROM BYPASS
TRAY.
NO 2IN1 COPY FROM
BYPASS TRAY.
NO 2IN1 COPY WITH MARGIN
SHIFT.
COPY RATIO CAN NOT BE
CHANGED IN 2IN1.
THIS MENU IS NOT SELECTABLE
WITH DATA.
NO XXXX SIZE TRAY
CHECK ADF/RADF.
START TO RESUME.
LOAD XXXX PAPER INTO TRAY<*>.
NO PC COMMUNICATION; CHECK
CABLE.
62
Indication
Display
INSTALL A TONER
CARTRIDGE.
TONER
CARTRIDGE IS
NEAR EMPTY.
MAINTENANCE
REQUIRED CALL
FOR SERVICE
Get other manuals https://www.bkmanuals.com
Cause and remedy
The toner cartridge is not installed
correctly. Reinstall the toner cartridge.
Replacement of toner cartridge will be
needed soon. Prepare a new cartridge.
Service by an authorized TOSHIBA
service technician is required.
Data is being held in memory. Print the
data or clear it from memory.
Two sided printing or 2 IN 1 copying is
selected when the bypass tray is already
selected ,or the bypass tray is selected
when two-sided printing or 2 IN 1
copying is already selected.
The bypass tray cannot be used. Press
the [TRAY SELECT] key (
a paper tray.
2 IN 1 copy and margin shift cannot be
used in combination. Cancel the
function that was selected last.
Copy ratio can not be changed in 2 IN 1
copy.
This appears if you attempt to change a
user program setting while a print job is
in progress.
There is no paper for printing. Press the
[MODE SELECT] key to switch to printer
mode and follow the instructions in the
display.
("XXXX" indicates paper size)
An original remains on the document
glass, or the original is too thick to scan.
Remove the original.
If the message is not cleared when there
is no original on the document glass, the
underside of the document cover/RADF
is dirty. Clean the underside of the
document cover/RADF. (especially
areas where black lines appear.)
Printing is not possible if the paper size
setting is different from the size of paper
loaded in the tray. Load the same size of
paper as the paper size setting and then
press the [START] key (
begin.
("XXXX" indicates paper size. The tray is
indicated in <*>.)
The machine is not correctly connected
to the computer. Check the cable (when
using the scanner function).
Page
74
74
-
30
26
31
) to select
31
34
25
31
54
-
21
78
15
). Printing will
42
Advertisement
Table of Contents
Troubleshooting
