Table of Contents
Advertisement
Setup
Use only water-based or oil-based (mineral
spirit-type) materials with flash point greater than
100° F (38° C). Do not use materials which state
"FLAMMABLE" on the packaging. For more informa-
tion about your material, request MSDS from distribu-
tor or retailer.
Spraying certain materials may cause static
build-up in the sprayer that can result in static
shock to the user. If this occurs, first ensure the mate-
rial has a flash point greater than 100° F (38° C) and
does not state that it is FLAMMABLE anywhere on the
package. If still feeling a static shock, the material likely
contains a non-mineral spirits fluid such as, but not lim-
ited to, xylene, toluene, or naphtha, which can build up
static. Switch to an alternative material.
Use oil-based material outdoors or in a well-ventilated
indoor area with a flow of fresh air.
Keep spray area well-ventilated. Keep a good supply
of fresh air moving through the area.
Your sprayer is NOT compatible with harsh cleaners
such as chlorine bleach. Using these cleaners will
cause damage to the sprayer.
Suction Tube Selection
This sprayer comes with two different suction tubes.
Standard Suction Tube (sprays ceilings and walls):
When spraying walls, the inlet of the suction tube should
be aimed at the front of the material cup.
8
NOTICE
ti15476a
When spraying ceilings, the inlet of the suction tube
should be aimed at the back of the material cup
(towards the trigger).
Specialized Suction Tube (sprays floors):
When spraying floors, the inlet of the suction tube
should be aimed at the front of the material cup (towards
Spray Tip/Guard Assembly).
NOTE: If the sprayer is angled or tilted too far, the
suction tube will lose contact with the material and
the sprayer will stop spraying.
Setup
ti15475a
ti15477a
3A1456A
Advertisement
Table of Contents
