Table of Contents
Advertisement
& Clock (Vehicle with Naviga-
tion System)
NOTE
If your vehicle is a 2.5-liter non-turbo
model equipped with a navigation sys-
tem, refer to the separate "Operating
Instructions for Monitor System".
For turbo models and 3.0-liter models
equipped with a navigation system, the
clock can be shown on the multi-informa-
tion display.
The time shown by the clock receives the
time information from the navigation sys-
tem. To adjust the time shown by the
clock, refer to the separate "Operating
Instructions for Monitor System" and
adjust the time of the navigation system.
CAUTION
To ensure safety, do not attempt to
S03BE10
set the time during driving, as an
accident could result.
& SI-DRIVE display
1)
Sport Sharp (S#) mode
2)
Sport (S) mode
3)
Intelligent (I) mode
4)
Throttle angle
*:
This display means that the Sport Sharp
(S#) mode is in the selected condition.
This indicates the current SI-DRIVE mode
with its throttle angle.
For details of SI-DRIVE mode, refer to the
"
SI-DRIVE (Turbo and 3.0-liter models)"
s07bc
section in chapter 7.
Black plate (135,1)
Instruments and controls
& Meter settings
The following items can be set or regis-
tered on the multi-information display as
desired.
. Initial movements of the meter/gauge
needles
. Present date & time
. Birthday
S03BE11
. Anniversary
Within 10 seconds after turning on the
ignition switch, press the " /SET" switch
for at least 2 seconds.
The display can be switched as shown
below by pressing the "
* "Present date & time", "Birthday" and
"Anniversary" can be registered in the
"Date/Time" setting menu.
Refer to the following procedure for further
steps.
!
Initial movement setting
It is possible to activate or deactivate the
北米Model "A2440BE-A" EDITED: 2006/ 12/ 6
3-15
S03BE12
3
" or "
" switch.
S03BE1201
– CONTINUED –
Advertisement
Chapters
Table of Contents
