Figure 28. Remove the strip cover
Go to
https://support.lenovo.com/partslookup
part:
Strip cover
Remove the LCD module
Make sure the following FRUs (CRUs) have been removed.
"Remove the lower case" on page 30
"Remove the solid-state drive (SSD) plate (L)" on page 31
"Remove the solid-state drive (SSD) plate (R)" on page 32
"Remove the thermal module" on page 39
"Remove the strip cover" on page 44
Step 1.
Disconnect the EDP cable from the system board and then remove four screws.
Figure 29. Disconnect the EDP cable from the system board and remove four screws
Screw specifications
M2 x L3
M2.5 x L7
to look up the Lenovo part number of the following replacement
Number of screws
2
2
.
Chapter 4
Removing a FRU or CRU
45