Power Connection - Grizzly G0637HEP Manual

56. Open the control box and identify the four
mounting holes in the back of the cabinet.
57. Attach the control box to the bracket already
mounted on the stand brace with (4) M6-1 x
15 Phillips head screws, (4) 6mm flat wash-
ers, and (4) M6-1 hex nuts (see Figure 50).
Figure 50. Model G0638 control box mounted.
If the control box is locked, use the included
key to unlock it for access to complete set
up. Always lock the box and keep the key in
a safe and secure location to prevent unau-
thorized access.
Model G0637/G0638 (Mfd. Since 04/12)

Power Connection

Due to the complexity required for planning,
bending, and installing the conduit necessary
for a code-compliant hardwire setup, an electri-
cian or other qualified person MUST perform
this type of installation. Hardwire setups typically
require power supply wires to be enclosed inside
of a solid or flexible conduit, which is securely
mounted at both ends with the appropriate con-
duit fittings. All work must adhere to the required
electrical codes.
The hardwire setup for this machine must include
a locking disconnect switch (see Figure 51)
between the power source and the machine. This
switch serves as the means to completely discon-
nect the machine from power to prevent elec-
trocution accidental startup during adjustments,
maintenance, or service to the machine.
Locking
Disconnect Switch
Power
Source
Conduit
Ground
Figure 51. Typical hardwire setup with a locking
disconnect switch.
Machine
Conduit
Ground
-31-