Table of Contents
Advertisement
3.
Use (16)
⁄
"-16 x
3
8
washer, and (16)
nect the two sides of the upper stand with
two upper stand braces and two lower stand
braces—only finger tighten the fasteners
(see Figure 18).
Figure 18. Upper stand assembled.
4.
Place the level across a corner of the lower
stand braces and move the upper stand
around until that corner is level, then fully
tighten all of the fasteners for that corner (see
Figure 19).
Figure 19. Level positioned on the upper stand.
5.
Repeat Step 4 for the rest of the corners,
then set the upper stand assembly aside.
-22-
⁄
" hex bolts, (32)
⁄
" flat
3
3
4
8
3
⁄
"-16 lock nuts to con-
8
When using power lifting equipment dur-
ing the assembly, make sure the equipment
is safe, fully operational, and adequately
rated for the weight being lifted. The opera-
tor of the equipment must be experienced
and able to use safe methods during these
processes. Failure to heed these warnings
could result in serious personal injury or
death.
6.
Place the intake cylinder on the floor and
apply the 3 x 6 x 1800mm gasket to the
intake cylinder top rim, between the mounting
holes and the inside edge (see Figure 20).
Gasket
Figure 20. Gasket applied to the intake cylinder
rim.
7.
With assistance and the power lifting equip-
ment, keep the intake cylinder on the floor
and lower the blower housing over the top of
the intake cylinder.
Model G0637/G0638 (Mfd. Since 04/12)
Advertisement
Table of Contents
