Table of Contents
Advertisement
SHORTCUT OPERATIONS
CTCSS/DCS Scan
Press
key, the top left corner of LCD displays "
enter into CTCSS/DCS scan. Under this state, rotate channel switch to change scan
direction. When scan the matching CTCSS/DCS signaling, it will stay 5seconds and
then go on scanning. Press any other keys except
NOTE: This function is invalid when transceiver works in professional mode or the
main channel no setting CTCSS/DCS signaling.
In main channel, if signaling set as CTCSS, it will scan CTCSS, if sets as DCS, will
scan DCS.
Offset Frequency Direction Setup
Under standby state, press
press
key to choose offset frequency direction. There are 3 options, Positive
offset, Minus offset, shut off offset.
1. (+) Positive offset: Indicates TX frequency is higher than RX frequency. When
enable reverse function, the RX frequency is higher than TX frequency.
2. (-) Minus offset: Indicates TX frequency is lower than RX frequency. When enable
reverse function, the RX frequency is lower than TX frequency.
3. None: Indicates shut offset off.
Under frequency mode (VFO) or channel mode, press
direction(+), minus offset direction (-) , shut offset off one by one (Please refer to offset frequency setup).
NOTE: This function is unavailable in professional transceiver mode.
,
key, the top left corner of LCD displays "
" icon, press
key to
,
key to exit.
" icon,
key then press
key to choose positive offset
22
Advertisement
Table of Contents
