Auto Auto lbs. Control Panel 10min Door Latches 1min 10s. 1 min + G643C Open Door Push Button Glass Plate Metal Rack Guide Roller Auto Auto lbs. 10min 1min 10s. 1 min + G643C 203mm 356.5mm 489mm 361mm Samsung Electronics...
4-1 Replacement of High Voltage Transformer 1. Discharge the high voltage capacitor. 2. Disconnect all the leads. 3. Remove the mounting bolts. 4. Reconnect the leads correctly and firmly. H. V. Trans Screws Samsung Electronics...
1. Insertion depth of the thin metal plate should be 0.5mm or less. 4-3-4 Removal of Key Door & Spring Remove pin hinge from Door "E" Detach spring from Door "E" and key door. Door "E" Key Door Spring Samsung Electronics...
1. Take out the outer panel ceramic 2. Disconnect the connectors from the heater ceramic Heater Bracket Upper and wire leade. 3. Remove screws securing the bracket upper to the oven cavity. 4. Remove one screw securing the bracket heater. Screw Bracket Heater Samsung Electronics...
3. When installing new membrane key board, make sure that the surface of escutcheon base is cleaned sufficiently so that any problems Membrane (shorted contacts or uneven surface) can be Panel avoided. Samsung Electronics...
2. Isolate the magnetron from the circuit by disconnecting its leads. 3. A continuity check across the magnetron filament terminals should indicate one ohm or less. 4. A continuity check between each filament terminal and magnetron case should read open. Cooling Fins Samsung Electronics...
∞ procedures. Primary switch ∞ Monitor switch (COM-NC) 5. Confirm that the gap between the switch ∞ Monitor switch (COM-NO) housing and the switch actuator is no more than ∞ Door Sensing S/W 0.5mm when door is closed. Samsung Electronics...
5. After heating for 2 minutes, measure the water temperature in each beaker. 6. Microwave heat distribution rate can be calculated as follows: Minimum Beaker Temperature Rise Heat Distribution = X 100(%) Maximum Temperature Rise The result should exceed 65%. Cooking Tray Samsung Electronics...
; CENTRAL SERVICE CENTER 5-13-2 At least once a year have the microwave energy survey meter checked for accuracy by its manufacturer. Samsung Electronics...
H.V.Transformer component test procedure and replace if it is H.V.Capacitor defective. H.V.Diode, H.V.Fuse Magnetron 4. Open or loose wiring of power relay 5. Defective primary latch switch 6. Defective power relay or Ass'y PCB Replace PCB main. Samsung Electronics...
Page 13
Use plastic wrap or cover with a lid. Stir once or twice while cooking foods such as soup, cocoa, or milk. Noise from the turntable motor Noise may result from the motor. Replace turntable motor. when it starts to operate. Samsung Electronics...
SYMBOL COLOR DOOR : P.C.B PATTERN BROWN MAIN POWER INRUSH GRILL SENSING BLUE : P.C.B IN/OUT RELAY RELAY RELAY RELAY SWITCH L.V.T ORANGE POINT WHITE BLACK YELLOW DOOR SENSING MONITOR PRIMARY GREEN LATCH LATCH SWITCH YELLOW/GREEN SWITCH SWITCH Samsung Electronics...