Table of Contents
Advertisement
Figure 62. Installing the M.2 SSD module
Next steps
1. Install the BOSS S1 card in the expansion card riser.
2. Install the
expansion card
3. Install the
air shroud.
4. Follow the procedure listed in the
PERC
This is a service technician replaceable part only.
Removing the adapter PERC
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the air
shroud.
4. Remove the
expansion card
Steps
1. Disconnect the SAS cables from the adapter PERC.
2. Pull out the adapter PERC from the PCIe slot on the expansion card riser.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
66
Installing and removing system components
riser.
After working inside the
Safety
instructions.
Before working inside your
riser.
system.
system.
Advertisement
Table of Contents
