Installing The Boss S2 Module - Dell PowerEdge T350 57C92 Installation And Service Manual

Figure 66. Removing the BOSS S2 module
Next steps
1. Replace the BOSS S2 module

Installing the BOSS S2 module

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the front bezel.
4. Remove the BOSS S2 module
5. Disconnect the BOSS S2 power and signal cable from the module and system board.
Steps
1. Align and slide the BOSS S2 module into BOSS S2 module cage and secure it with a screw using the Phillips 1 screwdriver.
78 Installing and removing system components
or Install the BOSS S2 module
Safety instructions.
Before working inside your
blank.
blank.
system.