Connect The Power Output Cord; Adjust The Voltage Level - Tekkeon MP3300 User Manual

3. Connect the adapter plug to the power output cord (but not the device).
If you are using a UA-xxx adapter (rather than PA-xxx),
you must insert the L34 adapter that came with your
myPower ALL between the adapter cord and UA-xxx
adapter as shown.
If you change the adapter plug while the power adapter
cord is connected to myPower ALL, the voltage setting
will reset to the lowest voltage (3V for MP3300, 5V for
MP3400), which is the default voltage setting.

Connect the Power Output Cord

1. Plug the large end of the power output cord into the DC OUT jack on the end of myPower ALL. The
3V (MP3300) or 5V (MP3400) voltage indicator will turn on to indicate that the voltage is set to the
lowest setting.
(If you have previously selected a voltage, the voltage selection will be returned to the lowest setting.)

Adjust the Voltage Level

1. Locate the voltage specification for your portable device.
This can be found on the device power adapter label or
device specification label which typically is found on the
bottom of the unit.
(If available, use the voltage specification shown on the power adapter.)
USER GUIDE
Sample Power Adapter Label
L34 Adapter for
myPower ALL
5