Holmes HM1851 - Cool Mist Humidifier Manual

HOW COOL MIST WORKS

Your Holmes Cool Mist humidifier draws dry air through the rear air intake grill area. This air is then passed through a moisture–laden wick filter, which retains the minerals and deposits in the water. The resulting moist air is directed back into the room from the top air grill.
NOTE: This humidification system provides a cool, invisible moisture output. It is normal not to see the mist.
NOTE:A humidity level below 20% can be unhealthy and uncomfortable. The recommended humidity level is between 40%-50%.

PRE-OPERATING INSTRUCTIONS

1. Select a location for your humidifier, on a flat surface, about 4" away from the wall. Do not place your humidifier on furniture; a floor location that will not be damaged by moisture is best.
2. Remove the water tank by holding the tank handle and lifting straight upward (see Figure 1).
   
   1. Water Tank
   2. Carry Handle
   3. FilterCheck Indicator
   4. Humidifier Housing
   5. 1Touch ® with ClearView™ Humidistat
   6. Filter Support
   7. Humidifier Base
3. Remove the main housing by lifting straight upward. Check to see that the wick filter is properly in place.
   Replace the humidifier housing.

FILLING THE WATER TANK

NOTE: This humidifier holds about 2.25 gallons of water in the tank and humidifier base. The humidifier will produce up to 4 gallons of moisture over a 24-Hour period, depending on the room humidity and temperature.

1. Push the 1Touch^® (MODE/OFF) button for 2 seconds to turn the unit OFF and disconnect from the electrical outlet.
2. Remove the tank from the base by holding the handle and lifting straight up (see Figure 1).
3. Twist off the tank cap located on the bottom of the tank by turning counter clockwise and fill the water tank with cool, fresh water. Do not fill with warm water as this may cause leaking.
4. After filling the tank, replace the tank cap by firmly turning clockwise and then replace the water tank on the base. The tank will immediately begin to empty into the base.
5. Plug the power cord into a 120V AC electrical outlet.

OPERATING INSTRUCTIONS

Your humidifier is equipped with a technologically advanced 1Touch^® Electronic Humidistat. You can set the humidifier to run continuously in manual mode or set the 1Touch^® Electronic Humidistat to your desired humidity setting. The 1Touch^® Electronic Humidistat will automatically turn the humidifier ON or OFF, depending on the preset comfort level. The comfort level ranges between 35% and 55% relative humidity.

MANUAL MODE INSTRUCTIONS

1. Plug the humidifier into a 120V AC electrical outlet.
2. To start the unit, push the MODE/OFF button once for the HI manual setting. (See Figure 1)
3. Press the button again for the LO manual setting. (See Figure 1)
4. To stop the unit, press and hold the MODE/OFF button for two seconds, or keep pressing the button until all the humidity indicators are OFF.

NOTE:In Manual Mode, only the LOor HIpower light will be lit.

1TOUCH^® HUMIDISTAT INSTRUCTIONS

To take advantage of the 1Touch^® Electronic Humidistat, press the MODE/OFF button until the speed is set in either the HIGH or LOW setting, and the Desired Humidity is set. When the humidity level rises above the set humidity, the humidifier will stop. When the humidity level drops below the set humidity, the humidifier will turn on automatically.
NOTE: When the 1Touch^® Electronic Humidistat is set, either the HI or LO power light and the percent humidity light will remain lit during operation. (See Figure 1.)
NOTE: Allow up to 30 minutes for the filter to fully absorb water and for the unit to produce moisture.
NOTE: The 1Touch^® Humidifier has memory. This means that when you turn the unit back on, it will be at the last setting the humidifier was set at.
If you do not plan to use the humidifier for two or more days, make sure any residual water is drained from the water tank, base and wick filter to prevent algae or bacteria growth.

EXTENDED RUN TIME SETTING:
By setting you humidifier to a specific humidity level, you are actually also extending the run time. Since the unit will turn on and off to maintain the set humidity level, less water will be used, so you will need to fill the unit less than you would on manual setting.

REPLACING THE FILTER

Through normal use, waterborne minerals and sediment become trapped in the wick filter. The harder your water, the greater the amount of minerals in the water, and the more often you will need to change your filter. You will be able to monitor the life of the filter in your humidifier by checking the FilterCheck^® Indicator. When the unit is off, the FilterCheck^® Indicator will read in the OFF position. After 60 minutes of use, FilterCheck^® Indicator (refer to Figure 2 for close-up of indicator) will move from the OFF position and indicate your filter condition. A brand new filter will register in the GOOD section. After frequent use of your humidifier, the FilterCheck^® Indicator will let you know when the filter needs to be changed.
When the needle is in the light CHANGE section, this means the proper amount of moisture is not getting into your air due to the excessive minerals and sediment that have become trapped on your filter. At this point, you should replace your filter. It is important to change your filter as indicated to obtain stated performance level.

To replace the filter, follow the steps below.

1. Push the 1Touch^® (MODE/OFF) button for 2 seconds to turn the unit OFF and disconnect from the electrical outlet.
2. Remove the tank and main housing to access the base tray (see Figures 1 and 3).
   
   1. Circular Filter Support
   2. Circular Filter
   3. Humidifier Base
3. Discard the old filter and follow weekly cleaning instructions.
4. Insert a new filter into the filter support in the base (Figure 3).
5. Replace the main housing and then the tank.
6. Repeat Operating Instruction steps.

It will take about 30 minutes for the humidifier to reach maximum output.
You can purchase replacement filters (model HWF65) by calling 1-800-5-HOLMES or by visiting www.holmesproducts.com.

CLEANING AND MAINTENANCE INSTRUCTIONS

Humidifiers provide comfort by adding moisture to dry indoor air. To get the most of the benefit from the humidifier and avoid product failure, follow all maintenance instructions carefully. If the recommended care and maintenance guidelines are not followed, microorganisms may be able to grow in the water within the humidifier.

DAILY MAINTENANCE

1. Before cleaning, be sure the humidifier is OFF and disconnected from the electrical outlet.
2. Lift off the tank and the housing of the humidifier. Remove filter and place in sink or tub as the filter will release water when not in the humidifier.
3. Carry the base and the tank to the sink, then drain and rinse the base and tank thoroughly to remove any sediment and dirt. Wipe clean and dry with a clean soft cloth or paper towel. (DO NOT use metal cleaning utensils or abrasive cleaners)
4. Put the filter back in the filter supports, replace the housing, then refill the tank with cool tap water as instructed in filling the water tank instructions.

WEEKLY MAINTENANCE
To Remove Scale:

1. Repeat steps 1-3 above.
2. Clean the base by partially filling the base with one 8-oz cup of undiluted white vinegar, or by using Cleanse Clean^® by Holmes. Let solution stand 20 minutes, clean all interior surfaces with a soft brush.
3. Dampen a cloth with undiluted white vinegar and wipe out entire base to remove scale.
4. Rinse with clean warm water to remove scale and the white vinegar solution before beginning to disinfect the tank.

To Disinfect Humidifier Base and Tank:

1. Fill tank with 1/2 teaspoon of chlorine bleach and 1/2 gallon of water.
2. Let the solution stand for 20 minutes, swishing every few minutes. Wet all surfaces.
3. Empty the tank after 20 minutes, and rinse well with water until the bleach smell is gone. Dry with a clean cloth or paper towel.
4. Refill the water tank with cool water; replace the housing and the water tank. Repeat ALL Operating Instructions.

Please DO NOT attempt to open or repair the humidifier. Please see the Warranty for Service Instructions or call consumer service at 1-800-5-HOLMES.

TROUBLESHOOTING

STORAGE INSTRUCTIONS

If your humidifier will not be in use for two days or more, or at the end of the season follow these instructions.

1. Clean, rinse and thoroughly dry the humidifier as directed in the weekly maintenance section. DO NOT leave any water inside the base or tray.
2. Remove the tank cap. Do not store with the tank cap in place.
3. Place the humidifier in the original carton and store in a cool, dry place.
4. Always clean the humidifier before the next season begins.
5. Order a replacement filter to start the next season.

REPLACEMENT ACCESSORIES

To order the replacement accessories you can do any of the following:

• Fill out the accessories card found with the product
• Visit your local retailer
• Go to www.holmesproducts.com
• Call consumer service at 1-800-5-HOLMES

SERVICE INSTRUCTIONS

1. DO NOT attempt to repair or adjust any electrical or mechanical functions on this unit. Doing so will void the Warranty.
2. If you need to exchange the unit, please return it in its original carton, with a sales receipt, to the store where youpurchased it. If you are returning the unit more than 30 days after the date of purchase, please see the enclosed Warranty.
3. If you have any questions or comments regarding this unit's operation or believe any repair is necessary, please writeto our Consumer Service Department or visit our website at www.holmesproducts.com.
   JCS/THG, LLC.
   CONSUMER SERVICE DEPARTMENT
   303 NELSON AVENUE NEOSHO, MO 64850
   For your own records, staple or attach your sales receipt to this manual. Also, please take a moment to write the store name/location and date purchased below.
   STORE NAME:
   LOCATION:
   DATE PURCHASED:
   (STAPLE RECEIPT HERE)

INFO HOT-LINE: If, after reading this owner's guide you have any questions or comments, please call 1-800-5-HOLMES and a Customer Service Representative will be happy to assist you.