Holmes HM500TG - Ultrasonic Cool Mist Humidifier Manual

FEATURES - OPERATIONS

PRE-OPERATING INSTRUCTIONS

1. Be sure the humidifier is switched off (knob turned all the way to the left).
2. Select a location for your humidifier, on a flat level surface about 4 inch away from the wall. DO NOT place the humidifier on a finished floor or near furniture, which can be damaged by too much moisture or water. Place on a moisture resistant surface.
3. Remove the tank from the main housing.
4. Bring the tank to the sink, turn upside down and twist off the tank cap by turning counter clockwise. Fill tank with cool, fresh tap water. DO NOT fill with warm water as this may cause leaking. Replace the cap on tank FIRMLY. The tank will hold 1/3 gallon of water. The humidifier will produce up to 1 gallon of mist water over a 24-hour time period.
5. Place tank back on to the base. The tank will immediately begin to empty into the base.
6. Plug the humidifier into a 120V electrical outlet.

OPERATING INSTRUCTIONS

1. To turn the unit on, turn the Volume Control knob Clockwise. Turning the knob all the way to the right will produce the highest moisture. Turning to the left will produce lower moisture with longer run time. The power light will be on when plugged in.
2. Rotate the Mist Nozzle to the desired mist direction.
3. When the humidifier runs out of water, the transducer will automatically shut off and the fan will keep running to dry any residual water out of the base and chamber.
4. Once the tank is empty, turn the Power Off and unplug the unit.
5. Before refilling the tank, empty any residual water from the base and tank. Follow daily maintenance instructions.
6. Fill tank with cool, fresh tap water. DO NOT fill with warm water as this may cause leaking. Replace the cap on tank FIRMLY.
7. Place tank on the base. The tank will immediately begin to empty into the base.
8. Plug the humidifier into a 120V electrical outlet.

DO NOT move the humidifier with water in the tank or the humidifier base. The moving action of the water may activate the water tank's release nozzle and overfill the transducer cavity. This may cause the humidifier to function intermittently, or stop emitting mist. Should this occur, simply remove the excess water from the humidifier base.

If you do not plan to use your humidifier for two or more days, make sure any residual water is drained from the water tank and base to prevent any algae or bacteria growth in stagnant water. Make sure the tank is dry.

NOTE: To avoid white dust use only distilled water especially if:

1. you suffer from respiratory problems or
2. you live in an area where the water has a high mineral content.

1. Tank
2. Carry Handle
3. Humidifier Base
4. Volume Control
5. Mist Nozzle
6. Transducer

CLEANING / MAINTENANCE

CLEANING AND MAINTENANCE INSTRUCTIONS

Humidifiers provide comfort by adding moisture to dry, heated indoor air. To benefit most from the humidifier and avoid product misuse, follow all instructions carefully. Please note that this is an electrical appliance and requires attention when in use.

In addition, if you do not follow the recommended care and maintenance guidelines, micro-organisms may be able to grow in the water within the humidifier's tank. You must routinely follow the cleaning procedures that follow in order to ensure proper, efficient operation of your humidifier. Proper maintenance and cleaning is essential to the continued performance of your unit and the avoidance of algae or bacteria build-up.

DAILY MAINTENANCE

1. Be sure the unit is OFF and is disconnected from the electrical outlet.
2. Remove the tank from the humidifier and place in sink or tub.
3. Drain any remaining water and rinse thoroughly to remove any sediment or dirt. Wipe clean and dry with a clean cloth or paper towel.
4. Refill with cool tap water. Do not overfill.

WEEKLY MAINTENANCE

To Remove Scale:

1. Repeat steps 1-3 above.
2. Clean the base by partially filling it with one 8-oz cups of undiluted white vinegar. Leave this solution in the tank for 20 minutes, while cleaning all interior surfaces with a soft brush. Gently scrub the area around the transducer with a soft brush. Remove the scale by wiping the entire base with a cloth dampened with undiluted white vinegar.
3. Rinse clean with warm water to remove cleaning solution before disinfecting the tank.

To Disinfect Tank

1. Fill humidifier tank 1/2 full with water and 1/2 tablespoon of chlorine bleach.
2. Let the solution stand for 20 minutes, swishing every few minutes. Wet all surfaces.
3. Carefully empty the tank after 20 minutes, and rinse with warm water until you can not detect any bleach smell. Dry with a clean cloth or paper towel.
4. Refill the water tank as directed in Operating Instructions, and turn the unit on.

STORAGE INSTRUCTIONS

When not using your humidifier for an extended period of time:

1. Clean, rinse and thoroughly dry the humidifier as directed in weekly maintenance. DO NOT leave any water in the unit when storing. Leaving water in the unit may render the unit inoperable for the following season.
2. Place the humidifier in the original carton and store in a cool, dry place.

REPLACEMENT ACCESSORIES

To order the replacement accessories you can do any of the following:

• Visit your local retailer
• Go to www.holmesproducts.com
• Call consumer service at 1-800-546-5637

If you have any questions regarding your product or would like to learn more about other Holmes^® products, please contact our Consumer Service Department at 1-800-546-5637 or visit our website at www.holmesproducts.com.

TROUBLESHOOTING

FREQUENTLY ASKED QUESTIONS

© 2016 Sunbeam Products, Inc. doing business as Jarden Consumer Solutions. All rights reserved. Distributed by Sunbeam Products, Inc. doing business as Jarden Consumer Solutions, Boca Raton, Florida 33431. Sunbeam Products, Inc. is a subsidiary of Newell Brands Inc. (NYSE: NWL).

Printed In China