Advertisement
• Using the special cord set, connect the shaver to an electrical outlet with
the motor switched off.
• When charging for the first time or when the shaver is not used for a few
months, leave the shaver to charge continuously for 4 hours.
• The charging light (5) shows that the appliance is being charged. When the
battery is fully charged, the charging light turns off. Intermittent blinking
after a while indicates that the battery maintains its full capacity. This can
also happen short term when charging after the battery was completely
discharged.
• A full charge provides 30 minutes of cordless shaving time depending on
your beard growth.
• Once the shaver is completely charged, discharge the shaver through
normal use. Then recharge to full capacity. Subsequent charges will take
about 1 hour.
• Maximum battery capacity will only be reached after several charging/
discharging cycles.
• 5-minute quick charge is sufficient for a shave.
Shaving
First, remove the adjustable comb (7): Using your thumbs, press against the
side clips of the adjustable comb so that they swing off in the direction of the
arrows (a). Activate the on/off switch (6). The floating foil frame automatically
adapts to your skin surface for a close, smooth shave.
For best results:
• Always shave before washing your face.
• At all times, hold the shaver at right angles (90°) to the skin (b).
• Stretch the skin and shave against the direction of beard growth.
• For pre-shaving after a few days of not having shaved, use the wide
trimmer (4a) to pre-cut long hairs. For a close, smooth shave, finish with
the foil.
• To maintain 100% shaving performance, replace your foil and cutter block
at least every 18 months or when worn.
This appliance is suitable for use in a bath or shower.
18
Advertisement
