Restrictions When Using - Hoover HTPS64MCTT/1 Instruction Manual

Using the Power Management
Using power management you can set the total power to 2.5kW/ 3.0kW/ 4.5kW/
6.5kW and 7.4kW. The default total power setting is the maximum power level.
Setting the total power level to fit your requirement
1. Make sure the cooktop is turned off.
Note: you can only set power management when the cooktop is turned off.
2. Touch the button "Stop + Go" and hold for 5 seconds. You can hear
the buzzer beeps one time.
3. After you hear the beep, touch "+" and "-" button at the same time
and hold for 3 second, the timer indicator will show flashing previous total power
level, e.g. '2.5'. Touch and hold " +" and "-" for 1 second again to switch to other
power level, for example 3.0. When the power that you want is flashing, touch the
button "Stop+Go" and hold for 5 seconds. The buzzer will beep 10 times. It means
you have finished the setting.
Note:
1. After step 2, you must touch the "+" and "-" within 3 seconds after you hear
the beep. Otherwise you will need to start again from step 2.
2. Once finish setting, wait till the end of 10 beeps. Do not touch any button during
this period. Otherwise the setting will be invalid.
Power management Rules
If total power exceeds the limitation of 2.5kw, 3.0kw, 4.5kw, 6.5kw (depending
on which level you've set), you are not able to increase power stage of any zone.
If you increase it by touching '+', the cooktop will beep 3 times and indicator will
show a flashing 'Pn'. Thus you need to decrease power stage of other zones before
increasing the power of objective zone.
EN-13
Using the Boost
Boost is the function that one zone rising to a larger power in one second and
lasting for 5 minutes. Thus you can get a more powerful and faster cooking.
Using the Boost to get larger power
1. Touch the control panel button that you wish to boost, then hold the "b" for 3
second. The power display will show "P" to indicate that the zone is boosting.
2. The Boost power will last for 5 minutes and then the zone
will go back to the "9" power stage.
3. If you want to cancel the Boost during this 5 minutes, touch the "B" button for
twice. The heating zone will go back to "9" power stage. Or slide along the "—" to
the left point, the heating zone will go back to the power stage in which you
touched.

Restrictions when using

The four zones were divided into two groups. In one group, if use boost on one
zone, first make sure that the other zone is working on/below power level 5.
or
EN-14