Pan Dimensions; Using Your Induction Hob - Hoover HTPS64MCTT/1 Instruction Manual

Pan dimensions

The cooking zones are up to a limit, automatically adapted to the diameter of the
pan. However the bottom of this pan must have a minimum of diameter according
to the corresponding cooking zone. To obtain the best efficiency of your hob,
please place the pan in the centre of the cooking zone.
The base diameter of induction cookware
Cooking zone Minimum (mm)
1, 2, 3, 4 (180mm) 120
Flex zone 240 or 160*270
The above may vary according to the quality of the pan used.

Using your Induction Hob

To start cooking
1. Touch the ON/OFF control.
After power on, the buzzer beeps once, all displays
show " – " or " – – ", indicating that the induction
hob has entered the state of standby mode.
2. Place a suitable pan on the cooking zone that
you wish to use.
• Make sure the bottom of the pan and the surface
of the cooking zone are clean and dry.
3.Select one heating zone and set a power level by touching the slider, or slide
along the "—" control, or just touch any point of the "—".
Or
EN-11
a. If you don't set the power within 1 minute, the induction hob will
automatically switch off. You will need to start again at step 1.
b. You can modify the heat setting at any time during cooking.
c. If slide along the "—", power will vary from stage 1 to stage 9.
If the display flashes
setting
This means that:
• you have not placed a pan on the correct cooking zone or,
• the pan you're using is not suitable for induction cooking or,
• the pan is too small or not properly centred on the cooking zone.
No heating takes place unless there is a suitable pan on the cooking zone.
The display will automatically turn off after 1 minutes if no suitable pan is placed
on it.
When you have finished cooking
1. Turn the cooking zone off by slide along the "—" to the left point, and then hold
for 1 second.
Make sure the power display shows "0", then shows "H".
and then
3.
Turn the whole cooktop off by touching the ON/OFF control.
4. Beware of hot surfaces
'H' will show which cooking zone is hot to touch. It will disappear when the
surface has cooled down to a safe temperature. It can also be used as an
energy saving function if you want to heat further pans, use the hotplate that
is still hot.
alternately with the heat
EN-12