Nl Originele Handleiding - Hilti NURON SBT 6-22 Original Operating Instructions

Trouble or fault
Predrilling in BT mode stops
prematurely.
Hole not correctly drilled or
stud not correctly driven.
10 Disposal
WARNING
Risk of injury due to incorrect disposal! Health hazards due to escaping gases or liquids.
▶ DO NOT send batteries through the mail!
▶ Cover the terminals with a non-conductive material (such as electrical tape) to prevent short circuiting.
▶ Dispose of your battery out of the reach of children.
▶ Dispose of the battery at your Hilti Store, or consult your local governmental garbage disposal or public
health and safety resources for disposal instructions.
Most of the materials from which Hilti products are manufactured can be recycled. The materials must be
correctly separated before they can be recycled. In many countries, your old tools, machines or appliances
can be returned to Hilti for recycling. Ask Hilti Service or your Hilti sales representative for further information.
▶ Do not dispose of power tools, electronic equipment or batteries as household waste!
11 Manufacturer's warranty
▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
12 Further information
For more information on operation,
qr.hilti.com/manual/?id=2368265
This link is also to be found at the end of the operating instructions, in the form of a QR code.
Originele handleiding
1 Informatie over de handleiding
1.1 Bij deze handleiding
• Lees voor ingebruikname deze handleiding door. Dit is vereist voor veilig werken en storingsvrij gebruik.
• De veiligheidsinstructies en waarschuwingsaanwijzingen in deze handleiding en op het product in acht
nemen.
• De handleiding altijd bij het product bewaren en het product alleen met deze handleiding aan andere
personen doorgeven.
*2368265*
Possible cause
Contact force is too low.
Cutting bit blunt or clogged.
Operating instructions for the stud
not followed.
technology,
2368265
Action to be taken
Contact force in S-BT mode:
≥ 200 N
▶ Apply at least the specified
contact force to press the drill
bit against the workpiece.
▶ Change to the "Drilling" mode.
Set the torque and operating
mode selector ring to
▶ Clean the cutting bit.
▶ Insert a new drill bit. → page 23
▶ Follow the operating instruc-
tions for the S­BT stud.
environment and recycling,
.
follow this link:
Nederlands 27