Hilti NURON SBT 6-22 Original Operating Instructions page 31

6. Lift the drill / driver away from the working surface and release the control switch.
7. Check the drillhole in accordance with the operating instructions for the S­BT.
6.2.2 Screwing in S­BT stud
The ATC quick-acting electronic cut-out is not available in the "Screwing in S­BT stud" mode.
1. Set the gear selector switch to 1
2. Insert the stud holder. → page 23
3. Insert the S­BT stud into the stud holder.
4. Position the S­BT stud over the predrilled hole.
5. Fully depress the control switch, hold it down and apply contact pressure to the stud.
6. The torque limiter trips when the stud reaches the correct screw-in depth.
7. Release the control switch and lift the drill / driver away from the working surface.
8. Check the stud in accordance with the S­BT operating instructions.
6.3 Switching off
▶ Release the control switch.
▶ The product switches off.
7 Care and maintenance
WARNING
Risk of injury with battery inserted !
▶ Always remove the battery before carrying out care and maintenance tasks!
Care of the product
• Carefully remove stubborn dirt.
• Carefully clean the air vents, if present, with a dry, soft brush.
• Use only a slightly damp cloth to clean the housing. Do not use cleaning agents containing silicone as
these can attack the plastic parts.
• Use a dry, clean cloth to clean the contacts of the product.
Care of the Li­ion batteries
• Never use a battery with clogged air vents. Clean the air vents carefully using a dry, soft brush.
• Avoid unnecessary exposure of the battery to dust and dirt. Never expose the battery to high levels of
moisture (e.g. by being dipped in water or left in the rain).
If a battery has been soaked by moisture, treat it as a damaged battery. Isolate it in a non-flammable
container and consult Hilti Service.
• Keep the battery free of extraneous oil and grease. Do not permit dust or dirt to accumulate unnecessarily
on the battery. Clean the battery with a dry, soft brush or a clean, dry cloth. Do not use cleaning agents
containing silicone as these can attack the plastic parts.
Do not touch the contacts of the battery and do not remove the factory-applied grease from the contacts.
• Use only a slightly damp cloth to clean the housing. Do not use cleaning agents containing silicone as
these can attack the plastic parts.
Maintenance
• Check all visible parts and controls for signs of damage at regular intervals and make sure that they all
function correctly.
• Do not use the product if signs of damage are found or if parts malfunction. Immediately have the product
repaired by Hilti Service.
• After cleaning and maintenance, install all guards and protective devices and check that they are in full
working order.
To help ensure safe and reliable operation, use only genuine Hilti spare parts and consumables. Spare
parts, consumables and accessories approved by Hilti for use with your product can be found at your
Hilti Store or online at: www.hilti.group
*2368265*
8
→ page 24 and set the forward/reverse switch to "forward". → page 24
2368265 English 25