Edit To O R From Another Vcr - JVC HR-S7500U Instructions Manual

ED ITIN G
Edit To O r
From Another
VCR
Player
S VIDEO OUT
S-Video cable
(supplied)
S VIDEO IN
VIDEO IN
Recorder
Advantages O f S-VH S Editing
S-VHS allows you make high resolution video recordings
when dubbing from one VCR to another.
You can edit from VHS to S-VHS, from S-VHS to VHS, or
from S-VHS to S-VHS.
● From VHS to S-VHS (VIDEO-VIDEO connection): Record
VHS playback signals in the S-VHS mode. Although the
picture quality is inherently limited by the orignal VHS
source material, the edited tape has better picture quality
than those made by VHS-to-VHS editing.
● From S-VHS to VHS (VIDEO-VIDEO connection): Because
the picture quality of the source material is very high, the
edited tape has better picture quality than those made by
VHS-to-VHS editing.
● From S-VHS to S-VHS (S-VIDEO connection): A high
resolution copy is made of a high resolution original S-
VHS tape with minimal picture degradation. This is the
preferred method of video dubbing.
Downloaded from: https://www.usersmanualguide.com/
VIDEO OUT
Your VCR
AUDIO
OUT
Audio/Video cable
(supplied)
AUDIO IN
Another VCR
You can use your VCR as the player or the recorder.
MAKE CO N N ECTIO N S
Connect an AV cable between the player's VIDEO OUT
1
and AUDIO OUT connectors and the recorder's VIDEO
IN and AUDIO IN connectors.
● If using another VCR with an S-VIDEO input or
output connector, it is recommended to use the S-
VIDEO connection to minimize picture degradation
while editing.
● When using your VCR as the recorder and a monaural
VCR as the player, connect the player's AUDIO OUT
connector to the AUDIO IN L connector on the recorder.
LO AD CASSETTES
Insert the playback cassette into the player and the
2
cassette to be recorded on into the recorder.
SET RECO RDER'S IN PUT
MO DE
Set to "AUX". With this VCR, press the N U M BER key "0"
3
and/or CH to select depending on the connector being
used – "L-1" for the rear AUDIO/VIDEO IN connector,
or "F-1" for the front AUDIO/VIDEO IN connector.
N O TE:
If you use your VCR as the recorder and have connected
another VCR to your VCR's S-VIDEO IN connector, you
need to set "REAR AUX INPUT" to "S-VIDEO" at the
Function screen. Follow steps 4 – 6 from the "Edit From
A Camcorder" section (
EN GAGE T APE DUBBIN G
MO DE
Follow steps 12 – 14 from the "Edit From A Camcorder"
4
section ( pg. 57).
ST ART PLAYER
Set to its play mode.
5
N O TE:
If the player is equipped with a superimpose/OSD
disable feature then set "SUPERIMPOSE" to OFF before
pressing PLAY ( pg. 28).
ST ART RECO RDER
Set to its record mode.
6
N O TES:
● Be sure to set "TAPE DUB MODE" back to "OFF" when you
finish editing.
● When "TAPE DUB MODE" is set to "ON" Active Video
Calibration is deactivated in order to provide better picture
quality edits.
● If you use an auxiliary input to connect a cable box or DBS
receiver make sure that the correct input ("L-1", "F-1" or "S-
VIDEO") is selected after you have finished editing (
page 56 ).
55
EN
pg. 56 – 57).
step 6 ,