Table of Contents
Advertisement
Settings
Two types of settings are available for the cloud adaptor:
Simple setting and Advanced setting.
Refer to the following descriptions to select a setting method
appropriate for the purpose.
Refer to the fi gure on the right for switches, etc. used for the setting.
• Simple settings:
When the switch inside the product is pressed at startup of the
product, "Adaptor Setting" (P.11) and "Air Conditioner Setting" (P.12)
are automatically set.
The procedures for the simple setting vary depending on the IP address
acquisition method for the network to which this product is connected.
* For the IP address acquisition method for the network, ask the network
administrator.
a) When acquiring the IP address from DHCP
→ Follow the procedure in "Simple Settings (DHCP)". (P.5)
b) When using the static IP address
→ Follow the procedure in "Simple Settings (Static IP Address)" (P.6)
• Advanced settings:
Start up the browser on the PC connected to this unit, and confi gure all
settings from the PC. (P.8)
Confi rm the following ports are permitted in the fi rewall of the
network to be installed.
* Confi rm with the network administrator.
TCP: 80, 3567
UDP: 53, 123
Simple Settings
Simple Settings (DHCP)
Confi rm the power is turned off .
1
Power Switch
Using the DIP switch, set the mode of the cloud adaptor
2
to the operation mode.
Do not change the setting
of switch 1 from the ON
position.
Change the setting of
switch 2 to OFF position.
Connect the cloud adaptor to the network.
3
Turn the power on.
4
Confi rm that the Green LED (LED 18) lights up and after a while,
the Orange LED (LED 17) blinks at high speed.
ON
Lighting
(Green)
Power Switch
If the Orange LED (LED 17) does not blink at high speed even after a
while, refer to "Self-diagnostics table and detected contents". (P.14)
Off
LED
18
OFF
Operation mode
2
ON
OFF
1 2 3 4
LAN Cable
network
Blinking
(Orange)
Off
Off
LED
LED
LED
17
16
15
ON
Power Switch
Cloud adaptor
Start up the unit in simple setting mode.
5
• While the Orange LED (LED 17) is blinking at high speed, the unit
is in simple setting mode selection standby. Press and hold the
SW6 switch for at least 1 second within 10 seconds. When the
LED changes to the simple setting mode, release the switch.
Simple setting mode:
The Orange LED (LED 17) lights up and the Green LED
(LED 16) and Red LED (LED 15) blink at low speed.
• If the SW6 switch is not pressed within 10 seconds, the simple
setting mode is not performed and the unit starts up in operation
mode. In this case, perform the procedure from step 1 again.
LED
LED
LED
17
16
15
• If the simple setting fails halfway, an error status is displayed on
LEDs and the setting is canceled.
• Refer to "Self-diagnostics table and detected contents" (P.14) and
check the error status.
• When the simple setting has fi nished normally, the unit
automatically restarts in operation mode and is connected to the
cloud server.
Self-diagnostics function LED
• The product status is shown with blinking and
lighting patterns of LED 15 to 17. (See P.14)
Power LED
LED
LED
LED
17
16
15
ON
DIP switch
• Operate these switches during
setting as needed.
Simple setting mode
Simple setting
selection standby
mode
Blinking
Lighting
(Orange)
Off
(Orange)
Off
Blinking
(Green)
Blinking
(Red)
5
Advertisement
Table of Contents
