Table of Contents
Advertisement
5.4 Intercom panel installation
Warning:
The product must not be connected to the power supply before the wiring has been
completed.
1
4
1
1
2
3 4 5 6
Avidsen
19 avenue Marcel Dassault
37200 TOURS
FRANCE
IP44
7
1 - Remove the tamper-resistant screw from the intercom panel.
2 - Tip the intercom panel cover forward.
3 – The intercom's lens should be approximately 1.60m above the ground.
4 – Mark the locations.
5 - Drill.
6 - Use pegs adapted to the type of support (the screws supplied are suitable for solid walls).
7 – Connect the two wires from the monitor and, if necessary, connect the electric strike plate and
the gate (see section 1. Wiring).
8 – Insert the screws and refit the two caps concealing the retaining screws.
2
5
2
1
1
2
8
Philips - Lite - V1
1m60
3
6
9
7
Advertisement
Table of Contents
