ADTRAN jobAid PR30 Manual

Product P/N: 1442548F1C
Documentation for ADTRAN Carrier Networks products is available for
viewing and download directly from the ADTRAN Support Community
website.
Go to: https://supportforums.adtran.com/welcome
Registration is required.
ADTRAN offers training courses on our products, including customized
training and courses taught at our facilities or at customer sites.
For inquiries, go to: http://adtran.com/training
D
ESCRIPTION
The PR30 Small Form-factor Pluggable (XFP) is a single-
mode fiber XFP that plugs into an ADTRAN optical interface
designed to accept XFPs. The XFP provides a single optical
interface to a physical interface, and is intended for use
with a 10 Gbps Passive Optical Network (PON) Optical Line
Termination (OLT) module. Installed into an appropriate
module, the XFP provides a 10G PON interface to the
supporting system.
The PR30 XFP OLT Transceiver uses standard 1270 nm/
1577 nm optics. The 1270-nm optical burst mode receiver
incorporates APD/TIA optics for maximum sensitivity. The
10 Gigabit transmitter incorporates a 1577-nm EML DFB
laser assembly.
The following features are supported on the XFP:
■ Data rate: 10 Gbps, symmetrical (PR30 denotes
symmetrical high-power budget)
■ Transmit Wavelength: 1577 nm
■ Receive Wavelength: 1270 nm
Optical distance: 20 km maximum
■
■ Hot Pluggable
!
CAUTION
Due to compliance certification requirements, use only XFPs
supplied by ADTRAN. ADTRAN cannot certify system integrity
with other XFPs.
Small Form-factor Pluggable
PR30 10G PON
OLT Transceiver
The following related online documents and resources provide additional information for this
product:
SFP/XFP/SFP+ Compatibility Matrix (online tool, go to: http://www.adtran.com/sfp)
I
NSTALLATION
Before installing the equipment, inspect the XFP. If damage has
occurred during shipping, file a claim with the carrier, and then
contact ADTRAN Customer Support. For more information, refer
to the warranty.
Installation Steps
To install the XFP into an appropriate module, complete the
following steps:
NOTE
Do not remove the protective end cap from the XFP until the fiber
optic cable is ready to be connected.
1. Insert the XFP into the PON cage on the OLT module.
NOTE
The latch on the XFP is for removal only. When removing the
XFP, rotate the latch away from the XFP. It should easily slide out
of the cage.
2. Do not remove the protective end cap until you have made
NOTICE
We recommend that the protective end cap remain on whenever
the transceiver optical fiber connector is not inserted.
3. Continue the installation and turn-up of the host module
S
PECIFICATIONS
Specifications for this XFP are as follows:
■ Optical
♦
♦
♦
♦
Document P/N: 61442548F1C-22B
Ensuring that the latch on the XFP is facing upward, slide it
all the way into the PON cage until there is an audible
"click."
the optical fiber connection.
using the instructions in the Job Aid provided with the
module or other system-level documentation, available
online at www.adtran.com.
Optical transmit level: +2.0 dBm to +5.0 dBm
Optical receive level: –28 dBm to –8 dBm
Optical Connectors: SC/UPC
Compatible with XFP MSA
jobAid
Issue Date: June 2016
1