Introduction; Purpose Of This Document; Technical Support - Siemens SITOP UPS1600 Getting Started

Introduction

1.1

Purpose of this document

This Getting Started guides you through configuring the UPS1600 under STEP 7 V13 for the
following two tasks:
● Buffering the S7 IO controller, including the I/O when the power fails
● Switching off the UPS when the power fails by the user program
Basic knowledge required
The following are required to understand the Getting Started:
● Knowledgeable about using personal computers with the Windows operating system
● Knowledgeable about how to configure an uninterruptible power supply using the
● Creating and editing projects under STEP 7 V13 in the TIA-Portal.
Range of validity
Getting Started is valid for STEP 7 V13.
1.2

Technical support

Technical support
Technical support for all IA/DT products can be accessed through the following
communication channels:
● Phone: + 49 (0) 911 895 7222
● E-Mail (mailto:support.automation@siemens.com)
● Internet:
Technical documentation on the Internet
Operating instructions and manuals for SITOP are available in the Internet:
Operating instructions/manuals (http://www.siemens.de/sitop/manuals)
SITOP power supply homepage
General news about our power supplies is available in the Internet at the SITOP home page
(http://www.siemens.de/sitop).
SITOP UPS1600 under STEP 7 V13
Getting Started, 06/2014
UPS1600, including the S7 IO controller and connected battery modules
Online support request form (http://www.siemens.de/automation/support-request)
1
5