Table of Contents
Advertisement
SAFETY MACHINE OPERATION
SAFETY RULES FOR TRAVELING
When traveling on level ground, keep the work equipment at a
height of 40 to 50 cm (16 to 20 in) from the ground.
If the work equipment blocks the view and it is difficult to travel
in safety, raise the work equipment to a greater height.
When traveling on rough ground, travel at low speed and do not
operate the steering suddenly. There is danger that the machine
may turn over. The work equipment may hit the ground surface
and cause the machine to lose its balance, or may damage the
machine or structures in the area.
When traveling on rough ground or steep slopes, if the machine
is
equipped
with
auto-deceleration switch OFF (cancel).
Avoid traveling over obstacles when possible. If the machine
has to travel over an obstacle, keep the work equipment close
to the ground and travel at low speed. Never travel over
obstacles which make the machine tilt strongly to one side.
When traveling or carrying out operations, always keep a safe
distance from people, structures, or other machines to avoid
coming into contact with them.
When passing over bridges or structures, check first that the
structure is strong enough to support the weight of the machine.
When operating in tunnels, under bridges, under electric wires,
or other places where the height is limited, operate slowly and
be extremely careful not to let the machine body or work
equipment hit anything.
TRAVELING ON SLOPES
To prevent the machine from tipping over or slipping to the side,
always do as follows.
Keep the work equipment approx. 20 to 30 cm (8 to 12 in) above
the ground. In case of emergency, lower the work equipment to
the ground immediately to help stop the machine.
When traveling uphill, set the machine with the operator's seat
on the uphill side; when traveling downhill, set the operator's
seat on the downhill side. Check that the ground under the
machine is safe when traveling.
2 - 24
auto-deceleration,
always
turn
the
SAFETY
Advertisement
Chapters
Table of Contents
