Safety Rules For Traveling; Traveling On Slopes - Komatsu PC750LC-7 Operation Manual

SAFETY

SAFETY RULES FOR TRAVELING

When traveling on flat ground, keep the work equipment 40 to 50
cm (16 to 20 in) high above the ground.
When traveling on rough ground, travel at low speed and do not
operate the steering suddenly. There is danger that the machine
may turn over. The work equipment may hit the ground surface
and cause the machine to lose its balance, or may damage the
machine or structures in the area.
When traveling on rough ground or steep slopes, if the machine
is equipped with
auto-deceleration switch OFF (cancel).
Avoid traveling over obstacles when possible. If the machine
has to travel over an obstacle, keep the work equipment close
to the ground and travel at low speed. Never travel over
obstacles which make the machine tilt strongly to one side.
When traveling or carrying out operations, always keep a safe
distance from people, structures, or other machines to avoid
coming into contact with them.
When passing over bridges or structures, check first that the
structure is strong enough to support the weight of the machine.
When traveling on public roads, check first with the relevant
authorities and follow their instructions.
When operating in tunnels, under bridges, under electric wires,
or other places where the height is limited, operate slowly and
be extremely careful not to let the machine body or work
equipment hit anything.

TRAVELING ON SLOPES

To prevent the machine from tipping over or slipping to the side,
always do as follows.
Keep the work equipment approx. 20 to 30 cm (8 to 12 in) above
the ground. In case of emergency, lower the work equipment to
the ground immediately to help stop the machine.
When travel up slopes, set the operator's cab facing uphill, when
travel down slopes, set the operator's cab facing downhill.
Always check the firmness of the ground under the front of the
machine when traveling.
auto-deceleration, always turn the
SAFETY MACHINE OPERATION
2 - 23