Craftsman GARDENTRACTOR 917.27528 Owner's Manual page 20

I&
WARNING: TO AVIOD SERIOUS INJURY, BEFORE PERFORMING ANY
SERVICE OR ADJUSTMENTS:
1. Depress clutch/brake pedal fully and set parking brake.
2. Place motion control lever in neutral (N) position.
3. Place attachment clutch in "DISENGAGED" position.
4. Turn ignition key to "STOP" and remove key.
5. Make sure the blades and all moving parts have completely stopped.
6. Disconnect spark plug wire from spark plug and place wire where it cannot
come in contact with plug.
TRACTOR
TO REMOVE MOWER
1. Place attachment clutch in "DISEN-
GAGED" position.
2. If equipped, turn height adjustment
knob to lowest setting.
3. Lower mower to its lowest position.
4. Disengage belt tension rod from lock
bracket.
CAUTION: Rod is spring loaded. Have
a tight grip on rod and release slowly.
5. Remove retainer spring holding anti-
swaybar to chassis bracket and
disengage anti-sway bar from bracket.
6. Remove four retainer springs from
front plate assembly and remove
plate.
7. Remove retainer springs from
suspension arms at deck and disen-
gage arms from deck.
8. Raise attachment lift to its highest
position.
9. Slide mower forward and remove belt
from electdc clutch pulley.
10.Slide mower out from under right side
of tractor.
TO INSTALL MOWER
Be sure tractor is on level surface and mower
suspension arms are raised with attachment
lift control. Engage perking brake.
1. Swing anti-sway bar to left side of
mower deck.
2. Slide mower under tractor with
deflector shield to right side of tractor.
IMPORTANT: Check belt for proper
routing in all mower pulley grooves.
3. If equipped, turn height adjustment
knob counterclockwise until it stops.
4. Lower mower linkage with attachment
lift control.
5. Be sure belt tension rod is in disen-
gaged position.
6. Install belt into electric clutch pulley
groove.
7. Place the suspension arms on
outward pointing deck pins. Retain
with double loop retainer spring with
loops up as shown.
Lock Bracket
Belt Tension Front
Rod Mower
(Disengaged_,, ,,_' 3racket
Position) _,
Chassis
Bracket
Retainer
Spring
Anti-Sw
Bar
USE PLIERS FOR
RETAINER SPRINGS
Suspension Arms
Double Loop
Retainer Springs
(Outward pointing
deck pins)
20
Electric Double Loop
Clutch Pulley Retainer Springs
Front Plate
=y
Single Loop
Retainer Springs
Flanged Pins
Front Mower
\ Bracket
/=,,