Siemens Gigaset E450 SIM Manual page 70

Closing the battery cover
¤
Hold the battery cover at a slight angle
and introduce the two lower lugs into
the casing first. Then close the cover so
that it clicks into place.
Locking the battery cover
Insert the catches on the lock ring or belt
clip into the notches in the casing and
make sure that the arrow markings on the
casing are facing those on the bottom of
the ring. Turn the lock ring or belt clip
clockwise to the end stop. When both
holes are horizontally aligned with the
upper edge of the handset the lock ring is
closed.
Opening the battery cover
Position both thumbs on the lock ring and
at the same time turn the lock ring or belt
clip anticlockwise and remove.
¤
Insert a coin into the cavity at the top of
the battery cover and twist it until the
cover opens.
Placing the handset in the base station
and registering
¤
Place the handset in the base with its
display facing upwards.
The handset registers automatically. Reg-
istration takes around 1 minute. During
this time
Regstr.Procedure
display and the name of the base station
flashes, e.g. Base 1. The handset will be
assigned the lowest unassigned internal
number (1–6).
This will appear in the display when regis-
tration is complete, e.g.
that the number 1 has been assigned. If
the internal numbers 1–6 are already
assigned to other units, the number 6 is
overwritten.
Notes:
– Automatic registration is only possible
while no-one is making calls using the base
station.
– Each key press interrupts the automatic
registration.
– If automatic registration does not work the
handset will have to be registered manually
(page 34).
– You can change the name of the handset
(page 37).
First Steps
appears in the
INT 1. This means
7