Debug Parameter; Fan Test; Dsp Update; Compensation Set - CanadianSolar CSI-100K-T400 Installation And Operation Manual

7. Normal Operation

7.5.13 Debug Parameter

This section is applicable to maintenance personnel only.
Debug Parameter as shown as below:
→
S16DAT1: +0000
S16DAT2: +0000
S16DAT3: +0000
S16DAT4: +0000
S16DAT5: +0000
S16DAT6: +0000
S16DAT7: +0000
S16DAT8: +0000
Press the UP/DOWN keys to scroll through items. Press the ENTER key to select.
Press the DOWN key to scroll and press the UP key to change the value.
Press the ENTER key to save the setting. Press the ESC key to cancel.
changes and return to the previous menu.

7.5.14 FAN Test

This section is applicable to maintenance personnel only.
Selecting "Fan Test" displays the sub-menu shown below:
YES=<ENT> NO=<ESC>
Fan Test is a factory test function. Press the ENTER key to start the test.
Press the ESC key to return to the previous menu.
.44.
Figure 7.24
Are you sure?
Figure 7.25
7. Normal Operation

7.5.15 DSP Update

The function is used for update the DSP.
This function is applicable by maintenance personnel only, wrong operation
will prevent the inverter from reaching maximum power.

7.5.16 Compensation Set

This function is used to calibrate inverter output energy and voltage. It will not impact the
energy count for inverter with RGM.
Two sections are included: Power Parameter and Voltage Parameter.
The screen shows:
YES=<ENT> NO=<ESC>
Power para:1.000
Figure 7.26 Power Rate Limit
Press the Down key to move the cursor.
Press the Up key to change the digit.
Please press the Enter to save the setting and press the ESC key to return to the previous
menu.
This setting is used for grid operators, do not change this setting unless
specifically instructed to.
.45.