Special Settings; Std Mode Settings; Restore Settings; Hmi Update - CanadianSolar CSI-100K-T400 Installation And Operation Manual

7. Normal Operation

7.5.7 Special Settings

This function is applicable by maintenance personnel only, wrong operation
will prevent the inverter from reaching maximum power.

7.5.8 STD Mode Settings

Selecting "STD Mode. Settings" displays the sub-menu shown below:
1. Working Mode Set
2.
Power Rate Limit
3.
Freq Derate Set
4.
10mins Voltage Set
5.
Power Priority
6.
Initial Settings
7.
Voltage PCC Set
This function is applicable by maintenance personnel only, wrong operation
will prevent the inverter from reaching maximum power.

7.5.9 Restore Settings

There are 5 items in initial setting submenu.
Restore setting could set all item in 7.5.7 special setting to default.
The
screen
shows
as
below:
YES=<ENT> NO=<ESC>
Figure 7.21 Restore Settings
Press
the
Enter
key
to
save
the
setting
after
setting
grid
off.
Press
the
ESC
key
to
return
the
previous
mean.
.42.
Are you sure?
7. Normal Operation

7.5.10 HMI Update

This section is applicable to maintenance personnel only.
Selecting "Updater" displays the sub-menu shown below:
HMI Current Ver.: 02
YES=<ENT> NO=<ESC>
Updater is for updating LCD firmware. Press the ENTER key to start the process.
Press the ESC key to return to the previous menu.

7.5.11 External EPM Set

This function is turned on when the EPM is external.
YES=<ENT> NO=<ESC>
Fail Safe Set:ON
Figure 7.23 Set the Fail Safe ON/OFF

7.5.12 Restart HMI

The
function
is
used
for
restart
the
HMI.
This function is applicable by maintenance personnel only, wrong operation
will prevent the inverter from reaching maximum power.
Figure 7.22
.43.