Table of Contents
Advertisement
7. Normal Operation
OV-G-V1: 300---480V
OV-G-V1-T: 0.01---9S
OV-G-V2: 300---490V
OV-G-V2-T: 0.01---1S
UN-G-V1: 173---336V
UN-G-V1-T: 0.01---9S
UN-G-V2: 132---319V
UN-G-V2-T: 0.01---1S
Startup-T: 10-600S
Table 7.2 Setting ranges for User-Def (L-N)
NOTE
The initial value of the User-Def standard is for reference only. It does
not represent a correct value suitable for use.
NOTE
For different countries, the grid standard needs to be set as different
according to local requirements. If there is any doubt, please consult
Canadian Solar service technicians for details.
7.5.2 Grid ON/OFF
This function is used to start up or stop the power generation of Canadian Solar Three Phase
Inverter (see Figure 7.18).
Figure 7.18 Set Grid ON/OFF
Screens can be scrolled manually by pressing the UP/DOWN keys. Press the ENTER key
to save the setting. Press the ESC key to return to the previous menu.
7.5.3 Clear Energy
Clear Energy can reset the history yield of inverter
These two functions are applicable by maintenance personnel only, wrong
operation will prevent the inverter from working properly.
.40.
OV-G-F1: 50.2-63Hz
OV-G-F1-T: 0.01---9S
OV-G-F2: 51-63Hz
OV-G-F2-T: 0.01---9S
UN-G-F1: 47-59.5Hz
UN-G-F1-T: 0.01---9S
UN-G-F2: 47-59Hz
UN-G-F2-T: 0.01---9S
Restore-T: 10-600S
Grid ON
Grid OFF
7. Normal Operation
7.5.4 Reset Password
This function is used to set the new password for menu "Advanced info." and "Advanced
information" (see Figure 7.19).
YES=<ENT> NO=<ESC>
Password: 0000
Figure 7.19 Set new password
Enter the right password before set new password. Press the DOWN key to move the cursor,
Press the UP key to revise the value. Press the ENTER key to execute the setting.
Press the ESC key to return to the previous menu.
7.5.5 Power Control
Active and reactive power can be set through power setting button.
There are 5 item for this sub menu:
1. Set output power
2. Set Reactive Power
3. Out_P With Restore
4. Rea_P With Restore
5. Select PF Curve
This function is applicable by maintenance personnel only, wrong operation
will prevent the inverter from reaching maximum power.
7.5.6 Calibrate Energy
Maintenance or replacement could clear or cause a different value of total energy. Use this
function could allow user to revise the value of total energy to the same value as before. If
the monitoring website is used the data will be synchronous with this setting automatically.
(see Figure 7.20).
YES=<ENT> NO=<ESC>
Energy:0000000kWh
Figure 7.20 Calibrate energy
Press the DOWN key to move the cursor, Press the UP key to revise the value. Press the
ENTER key to execute the setting. Press the ESC key to return to the previous menu.
.41.
Advertisement
Table of Contents
