Connecting Network Cable; Ac Power - TRENDnet TEG-224WS User Manual

26-port 10/100/1000mbps gigabit ethernet web smart switch 2×1000base-t plus, 24×10/100base-tx ports

Hide thumbs Also See for TEG-224WS:

Table of Contents

Connecting Network Cable

The Switch supports 10Mbps Ethernet or 100Mbps Fast Ethernet and

it runs both in half and full duplex mode using two pair of Category 5

cable.

The Switch also supports 2-Ports 1000Mbps Gigabit Ethernet that

runs in Auto-negotiation mode and 10Mbps Ethernet or 100Mbps Fast

Ethernet that runs both in half and full duplex mode and 1000Mbps

Gigabit Ethernet runs in full duplex mode using four pair of Category

5 Cable.

These RJ45 ports are Auto-MDI type port. The Switch can auto

transform to MDI-II or MDI-X type, so you can just make an easy

connection that without worrying if you are using a standard or

crossover RJ45 cable.

The Switch used the AC power supply 100-240V AC, 50-60 Hz. The

power switch is located at the rear of the unit adjacent to the AC

power connector and the system fan. The switch's power supply will

adjust to the local power source automatically and may be turned on

without having any or all LAN segment cables connected.

Table of Contents

Teg-224wsplus