Safety Definitions - Stanley 76003 Instruction Manual

1. SAFETY DEFINITIONS

The definitions below describe the level of severity for each signal word. Please read the manual and pay
attention to these symbols.
DANGER: Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury.
WARNING: Indicates a potentially hazardous situation which, if not avoided, could result in death or serious
injury.
CAUTION: Indicates a potentially hazardous situation which, if not avoided, may result in minor or moderate injury.
CAUTION: Used without the safety alert symbol indicates a potentially hazardous situation which, if not
avoided, may result in property damage.
Improper operation or maintenance of this product could result in serious injury and property damage.
Read and understand all warnings and operating instructions before using this equipment. When using
power tools, basic safety precautions must always be followed to reduce the risk of personal injury.
SAVE ALL WARNINGS AND INSTRUCTIONS FOR FUTURE REFERENCE.
WARNING:
 Do not use outside the design intent of Placing XXX Blind Rivets.
 Use only parts, fasteners, and accessories recommended by the manufacturer.
 Do not modify the tool in any way. Any modification to the tool is undertaken by the customer and will
be the customer's entire responsibility and void any applicable warranties.
 Prior to use, check for misalignment or binding of moving parts, breakage of parts, and any other
condition that affects the tool's operation. If damaged, have the tool serviced before using. Remove any
adjusting key or wrench before use.
 The tool must be maintained in a safe working condition at all times and examined at regular intervals
for damage and function by trained personnel. Any dismantling procedure will be undertaken only by
trained personnel. Do not dismantle this tool without prior reference to the maintenance instructions.
 The operating supply air must not exceed 7 bar (100 PSI).
 Operators and others in work area must wear ANSI Z87.1 CAN/CSA Z94.3 approved safety glasses with
side shields. Always wear safety glasses and ear protection during operation.
 Dress properly. Do not wear loose clothing or jewellery. Keep your hair, clothing and gloves away
from moving parts. Loose clothes, jewellery or long hair can be caught in moving parts.
 Do not operate a tool that is directed towards any person(s).
 DO NOT operate tool with the nose casing removed.
 Adopt a firm footing or a stable position before operating the tool.
 Prior to use, inspect airlines for damage, all connections must be secure. Do not drop heavy objects on
Hoses. A sharp impact may cause internal damage and lead to premature hose failure.
 Do not lift the placing tool by the hose. Always use the placing tool handle.
 Vent holes must not become blocked or covered.
 Disconnect the air hose from the tool before performing any maintenance, attempting to adjust, fit or
remove a nose assembly.
 Keep tool handles dry, clean, and free from oil and grease.
 When carrying the tool from place to place keep hands away from the trigger to avoid inadvertent
activation.
2