Chapter 2. Installation Guide; Hardware Installation; Tl-Wn652Ag/Tl-Wn653Ag Hardware Installation; Tl-Wn612Ag Hardware Installation - TP-Link TL-WN612AG User Manual

108m dualband(2.4ghz/5ghz) wireless adapter
Table of Contents

Advertisement

TL-WN612AG/TL-WN652AG/TL-WN653AG

Chapter 2. Installation Guide

2.1 Hardware Installation

2.1.1 TL-WN652AG/TL-WN653AG Hardware Installation

To install the adapter, follow these steps listed below:
1.
Turn off your desktop PC and disconnect the power.
2.
Open your PC case and locate an available PCI slot on the motherboard. Remove the metal
slot cover on the back of the PC. Check with your computer manufacturer for instructions if
needed.
3.
Slide the PCI Adapter into the PCI slot. Make sure that all of its pins are touching the slot's
contacts. Once the adapter is firmly in place, secure its fastening tab to your PC's chassis
with a mounting screw. Then, close your PC case.
4.
Reconnect your PC's power and turn on your desktop PC.

2.1.2 TL-WN612AG Hardware Installation

To install the adapter, follow these steps listed below:
1.
Locate an available CardBus slot on your laptop.
2.
With the connector pin end facing the CardBus slot and the label facing up, slide the Adapter
into the CardBus slot until it locks in place.
3.
The Status LED should Intermittent flashing when the Adapter is installed correctly.

2.2 Software Installation

2.2.1 Overview

The Adapter's Setup Wizard will guide you through the Installation procedure for Windows 98SE,
Me, 2000, XP. The Setup Wizard will install the TP-LINK Wireless Client Utility (TWCU) and
drivers.
When you install the hardware before installing the software, the system will prompt "Found New
Hardware Wizard", click Cancel, and run the Setup Wizard program on the CD-ROM.
The Setup steps for Windows 98SE, Me, 2000 and XP are very similar. The following setup steps
are for Windows 2000. For the Setup steps on Windows Vista, please follow the clues of the
screens.

2.2.2 Software Installation for Windows 2000

1.
Insert the Resource CD into your CD-ROM drive, and open the folder with the same name as
your product. Then double-click Setup.exe in the proper folder according to your operating
system to start the installation.
108M Wireless Adapter User Guide
3

Advertisement

Table of Contents
loading

This manual is also suitable for:

Tl-wn652agTl-wn653ag

Table of Contents