TP-Link TL-WA601G User Manual page 28

Figure 3-13 Add or Modify Wireless MAC Address Filtering entry
To add or modify a MAC Address Filtering entry, follow these instructions:
1. Enter the appropriate MAC Address into the MAC Address field. The format of the MAC
Address is XX-XX-XX-XX-XX-XX
00-0A-EB-B0-00-0B.
2. Enter a simple description of the wireless station in the Description field. For example:
Wireless station A.
3. Privilege - Selects the privileges for this entry, one of Allow / Deny / 64-bit / 128-bit /
152-bit.
4. WEP Key - If you select 64-bit, 128-bit or 152-bit in the Privilege field, enter any
combination of hexadecimal digits (0-9, a-f, A-F) in the specified length. For example:
2F34D20BE2.
5. Status - Select Enabled or Disabled for this entry on the Status pull-down list.
6. Click the Save button to save this entry.
To add additional entries, repeat steps 1-6.
Note:
When 64-bit, or 128-bit, or 152-bit is selected, WEP Key will be enabled.
To modify or delete an existing entry:
1. Click the Edit or Delete button in the Modify column in the MAC Address Filtering Table.
2. Enter the value as desired in the Add or Modify Wireless MAC Address Filtering entry
page, and click the Save button.
You can click the Enable All button to make all the entries effective, click the Disable All button
to make all the entries ineffective, click the Delete All button to delete all the entries.
Click the Next button to go to the next page and click the Previous button to return to the
previous page.
For example:
If you desire that the wireless station A with MAC address 00-0A-EB-00- 07-BE be able to access
the AP, the wireless station B with MAC address 00-0A-EB- 00-07-5F not be able to access the AP,
TL-WA601G 108M Wireless Access Point User Guide
(X is any
21
hexadecimal digit). For example: