15. Remove the canopy cover from the bottom of the
canopy (Fig. 15).
Helpful Hint: The downrod, yoke cover and
canopy cover are not used in this type of
installation.
16. Align the canopy with the holes in the top of motor
assembly. Then, secure the canopy to the top of
the motor assembly using the three closemount
screws from the hardware bag (Fig. 16).
Closemount Screw
17. Raise the fan and place the canopy on the hook of
the mounting bracket. Then, insert the receiver into
the mounting bracket with the flat side facing the
ceiling (Fig. 17).
CLOSEMOUNT INSTRUCTIONS
10
Fig. 15
Canopy
Cover
Fig. 16
Closemount
Screws
Fig. 17
Receiver
Canopy
Canopy
Hook