Table of Contents
Advertisement
A part or whole of a recorded programme has
been lost.
• If there is a power failure or the AC mains lead is
disconnected from the household mains socket
while recording or editing, the programme may
be lost or the HDD may become unusable. We
cannot offer any guarantee regarding lost
programmes.
Timer recording does not work properly.
• Refer to "Screen icons" pages. (
• You can set the start and finish time to make the
timer recording work successfully. (
Record Start Buffer, Timer Record Stop Buffer)
Auto Renewal Recording does not work
properly.
• The programme will not be overwritten in the
following cases:
– the recorded programme is protected
– any programme is being played back or copied
– a screen such as Video Menu is displayed
Instead, the programme will be saved as a
separate programme and that will be
overwritten.
The time recorded on the disc and the
available time shown do not add up.
• Available disc space display may be different
from actual.
Cannot record two programmes
simultaneously.
• When "DVB-via-IP Server" is set to "On", this
unit uses one tuner. As a result, the maximum
number of programmes that can be
simultaneously recorded with this unit is
reduced by one. Set "DVB-via-IP Server" to
"Off". (
45)
To make the available recording space.
• Delete unnecessary programmes. (
Use auto renewal recording for weekly or
change the automatic deletion settings. (
26)
Play
Cannot play back.
• The disc is dirty. (
• The disc is scratched or marked.
• The disc may not be able to play back if it was
not finalised or a Top Menu was not created on
the equipment used for recording.
• Refer to "Screen icons". (
• Depending on the encrypted service, it may not
19, 25)
be possible to play back certain programmes.
• Depending on the Ultra HD Blu-ray disc, it may
54, Timer
not be possible to perform playback unless this
unit is connected to the Internet.
You have forgotten your rating PIN.
• The rating level returns to the factory preset.
1 While the unit is on, press and hold [OK], the
yellow button and the blue button at the
same time for more than 5 seconds.
• "00 RET" is displayed on the front panel
2 Repeatedly press [1] (right) until "03 VL" is
displayed on the front panel display.
3 Press [OK].
• "INIT" is displayed on the front panel
Cannot play the disc on other players.
• Refer to "Play on other players". (
Broadcast
Picture regularly breaks up on some
channels.
• Adjust the reception with "Manual Tuning".
(
52, 53)
The channel which was once selectable
cannot be selected.
• Reveal the channel on the channel list.
34)
(
52, 53)
18,
5)
display.
display.
25)
75)
63
TQBS0166
Advertisement
Table of Contents
