Table of Contents
Advertisement
• If "On" is selected, the broadcast signal is
looped through by this unit and power
consumption in standby exceeds 0.5 W
slightly. (approx. 0.7 W)
• If "Off" is selected, the broadcast signal is
not looped through by this unit and power
consumption in standby becomes less than
0.5 W. (approx. 0.3 W)
Networked Standby
This unit can be used as a DLNA Server when
this unit is in standby. Available only when
"Quick Start" is set to "Off".
• On:
– Power consumption increases in standby.
(
69)
• Off:
– Power consumed in standby becomes
smaller (
69), but the unit cannot be used
as a DLNA Server.
Remote Control
Change the remote control code on the main unit
and the remote control if you place other
Panasonic products close together.
• Use "BD 1", the factory set code, under normal
circumstances.
1 Select the code, then press [OK].
2 While pressing [OK], press and hold the
number button ([1] to [6]) for more than
5 seconds.
3 Press and hold [OK] for more than 5 seconds.
4 Press [OK].
Clock
If the time is not set correctly, use the settings
listed in the method below.
• Automatic
Time and date are set from digital broadcasts.
• Time Zone
• Manual Setting
1 Select "Off" of "Automatic", then press [OK].
2 Change the setting.
3 Press [OK].
60
TQBS0166
• When the clock is set manually, you cannot perform
playing/recording/PAUSE LIVE TV/REWIND LIVE TV of
the programmes that are copy protected (Retention
limit). (
71)
PIN Entry
You can set/change the PIN for parental control.
1 Enter your 4-digit PIN with the number
buttons.
2 Enter the new 4-digit PIN with the number
buttons.
• Make a note of PIN in case you forget it.
3 Press [OK].
System Update
Software Update in Standby
When you set this unit to standby, software
(firmware) updates (
automatically at the time you have specified.
Software Update Now ( Broadcast ) (
Software Update Now ( Internet ) (
Software Licence
System Information
Display Software (firmware) version of this unit.
Initialize
Shipping Condition
All the settings except for some settings
return to the factory preset.
• The timer recording programmes are also
cancelled.
• The device password is also initialized.
(
58)
Default Settings
All the settings other than the tuning settings,
clock settings, language settings, rating PIN,
remote control code, device password, etc.
return to the factory presets.
49) are downloaded
49)
49)
Advertisement
Table of Contents
